Hi,

On 11/20/2015 08:49 PM, Priit Laes wrote:
On Sun, 2015-11-15 at 20:46 +0100, Hans de Goede wrote:
From: Reinder de Haan <patches...@mveas.com>

Note this commit only adds support for phys 1-3, phy 0, the otg phy,
is
not yet (fully) supported after this commit.


This patch seems to be causing following compile warning:

In file included from include/linux/io.h:25:0,
                  from drivers/phy/phy-sun4i-usb.c:28:
drivers/phy/phy-sun4i-usb.c: In function 'sun4i_usb_phy_write': 
./arch/arm/include/asm/io.h:94:2: warning: 'phyctl' may be used uninitialized 
in this function [-Wmaybe-uni
nitialized]
   asm volatile("strb %1, %0"
   ^
drivers/phy/phy-sun4i-usb.c:172:8: note: 'phyctl' was declared here
   void *phyctl;

Good catch, thanks the "break;" after the dev_err for the h3 case should be a 
return (this is a dead code path,
the dev_err is there to avoid people trying to actually use 
sun4i_usb_phy_write() with the h3 in
the future).

v2 of this patch fixing this is on its way.

Regards,

Hans




Signed-off-by: Reinder de Haan <patches...@mveas.com>
Signed-off-by: Hans de Goede <hdego...@redhat.com>
---
  .../devicetree/bindings/phy/sun4i-usb-phy.txt      |  1 +
  drivers/phy/phy-sun4i-usb.c                        | 67
+++++++++++++++++-----
  2 files changed, 53 insertions(+), 15 deletions(-)

diff --git a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
index 0cebf74..95736d7 100644
--- a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
+++ b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
@@ -9,6 +9,7 @@ Required properties:
    * allwinner,sun7i-a20-usb-phy
    * allwinner,sun8i-a23-usb-phy
    * allwinner,sun8i-a33-usb-phy
+  * allwinner,sun8i-h3-usb-phy
  - reg : a list of offset + length pairs
  - reg-names :
    * "phy_ctrl"
diff --git a/drivers/phy/phy-sun4i-usb.c b/drivers/phy/phy-sun4i-
usb.c
index b12964b..17f97ab 100644
--- a/drivers/phy/phy-sun4i-usb.c
+++ b/drivers/phy/phy-sun4i-usb.c
@@ -46,6 +46,9 @@
  #define REG_PHYBIST                   0x08
  #define REG_PHYTUNE                   0x0c
  #define REG_PHYCTL_A33                        0x10
+#define REG_PHY_UNK_H3                 0x20
+
+#define REG_PMU_UNK_H3                 0x10

  #define PHYCTL_DATA                   BIT(7)

@@ -79,7 +82,7 @@
  #define PHY_DISCON_TH_SEL             0x2a
  #define PHY_SQUELCH_DETECT            0x3c

-#define MAX_PHYS                       3
+#define MAX_PHYS                       4

  /*
   * Note do not raise the debounce time, we must report Vusb high
within 100ms
@@ -88,12 +91,19 @@
  #define DEBOUNCE_TIME                 msecs_to_jiffies(50)
  #define POLL_TIME                     msecs_to_jiffies(250)

+enum sun4i_usb_phy_type {
+       sun4i_a10_phy,
+       sun8i_a33_phy,
+       sun8i_h3_phy
+};
+
  struct sun4i_usb_phy_data {
+       struct device *dev;
        void __iomem *base;
        struct mutex mutex;
        int num_phys;
        u32 disc_thresh;
-       bool has_a33_phyctl;
+       enum sun4i_usb_phy_type type;
        struct sun4i_usb_phy {
                struct phy *phy;
                void __iomem *pmu;
@@ -164,12 +174,18 @@ static void sun4i_usb_phy_write(struct
sun4i_usb_phy *phy, u32 addr, u32 data,

        mutex_lock(&phy_data->mutex);

-       if (phy_data->has_a33_phyctl) {
+       switch (phy_data->type) {
+       case sun4i_a10_phy:
+               phyctl = phy_data->base + REG_PHYCTL_A10;
+               break;
+       case sun8i_a33_phy:
                phyctl = phy_data->base + REG_PHYCTL_A33;
                /* A33 needs us to set phyctl to 0 explicitly */
                writel(0, phyctl);
-       } else {
-               phyctl = phy_data->base + REG_PHYCTL_A10;
+               break;
+       case sun8i_h3_phy:
+               dev_err(phy_data->dev, "H3 usb_phy_write is not
supported\n");
+               break;
        }

        for (i = 0; i < len; i++) {
@@ -230,6 +246,7 @@ static int sun4i_usb_phy_init(struct phy *_phy)
        struct sun4i_usb_phy *phy = phy_get_drvdata(_phy);
        struct sun4i_usb_phy_data *data =
to_sun4i_usb_phy_data(phy);
        int ret;
+       u32 val;

        ret = clk_prepare_enable(phy->clk);
        if (ret)
@@ -241,15 +258,26 @@ static int sun4i_usb_phy_init(struct phy *_phy)
                return ret;
        }

-       /* Enable USB 45 Ohm resistor calibration */
-       if (phy->index == 0)
-               sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1);
+       if (data->type == sun8i_h3_phy) {
+               if (phy->index == 0) {
+                       val = readl(data->base + REG_PHY_UNK_H3);
+                       writel(val & ~1, data->base +
REG_PHY_UNK_H3);
+               }
+
+               val = readl(phy->pmu + REG_PMU_UNK_H3);
+               writel(val & ~2, phy->pmu + REG_PMU_UNK_H3);
+       } else {
+               /* Enable USB 45 Ohm resistor calibration */
+               if (phy->index == 0)
+                       sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN,
0x01, 1);

-       /* Adjust PHY's magnitude and rate */
-       sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5);
+               /* Adjust PHY's magnitude and rate */
+               sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE,
0x14, 5);

-       /* Disconnect threshold adjustment */
-       sun4i_usb_phy_write(phy, PHY_DISCON_TH_SEL, data-
disc_thresh, 2);
+               /* Disconnect threshold adjustment */
+               sun4i_usb_phy_write(phy, PHY_DISCON_TH_SEL,
+                                   data->disc_thresh, 2);
+       }

        sun4i_usb_phy_passby(phy, 1);

@@ -522,11 +550,14 @@ static int sun4i_usb_phy_probe(struct
platform_device *pdev)
        mutex_init(&data->mutex);
        INIT_DELAYED_WORK(&data->detect,
sun4i_usb_phy0_id_vbus_det_scan);
        dev_set_drvdata(dev, data);
+       data->dev = dev;

        if (of_device_is_compatible(np, "allwinner,sun5i-a13-usb-
phy") ||
            of_device_is_compatible(np, "allwinner,sun8i-a23-usb-
phy") ||
            of_device_is_compatible(np, "allwinner,sun8i-a33-usb-
phy"))
                data->num_phys = 2;
+       else if (of_device_is_compatible(np, "allwinner,sun8i-h3-
usb-phy"))
+               data->num_phys = 4;
        else
                data->num_phys = 3;

@@ -538,13 +569,18 @@ static int sun4i_usb_phy_probe(struct
platform_device *pdev)

        if (of_device_is_compatible(np, "allwinner,sun6i-a31-usb-
phy") ||
            of_device_is_compatible(np, "allwinner,sun8i-a23-usb-
phy") ||
-           of_device_is_compatible(np, "allwinner,sun8i-a33-usb-
phy"))
+           of_device_is_compatible(np, "allwinner,sun8i-a33-usb-
phy") ||
+           of_device_is_compatible(np, "allwinner,sun8i-h3-usb-
phy"))
                dedicated_clocks = true;
        else
                dedicated_clocks = false;

        if (of_device_is_compatible(np, "allwinner,sun8i-a33-usb-
phy"))
-               data->has_a33_phyctl = true;
+               data->type = sun8i_a33_phy;
+       else if (of_device_is_compatible(np, "allwinner,sun8i-h3-
usb-phy"))
+               data->type = sun8i_h3_phy;
+       else
+               data->type = sun4i_a10_phy;

        res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
"phy_ctrl");
        data->base = devm_ioremap_resource(dev, res);
@@ -620,7 +656,7 @@ static int sun4i_usb_phy_probe(struct
platform_device *pdev)
                        return PTR_ERR(phy->reset);
                }

-               if (i) { /* No pmu for usbc0 */
+               if (data->type == sun8i_h3_phy || i != 0) {
                        snprintf(name, sizeof(name), "pmu%d", i);
                        res = platform_get_resource_byname(pdev,
                                                        IORESOURCE_M
EM, name);
@@ -696,6 +732,7 @@ static const struct of_device_id
sun4i_usb_phy_of_match[] = {
        { .compatible = "allwinner,sun7i-a20-usb-phy" },
        { .compatible = "allwinner,sun8i-a23-usb-phy" },
        { .compatible = "allwinner,sun8i-a33-usb-phy" },
+       { .compatible = "allwinner,sun8i-h3-usb-phy" },
        { },
  };
  MODULE_DEVICE_TABLE(of, sun4i_usb_phy_of_match);
--
2.5.0

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to