Hi, On Fri, Jan 22, 2016 at 10:18 AM, Douglas Anderson <diand...@chromium.org> wrote: > The dwc2 scheduler (contained in hcd_queue.c) was a bit confusing in the > way it initted / kept track of which frames a QH was going to be active > in. Let's clean things up a little bit in preparation for a rewrite of > the microframe scheduler. > > Specifically: > * Old code would pick a frame number in dwc2_qh_init() and would try to > pick it "in a slightly future (micro)frame". As far as I can tell the > reason for this was that there was a delay between dwc2_qh_init() and > when we actually wanted to dwc2_hcd_qh_add(). ...but apparently this > attempt to be slightly in the future wasn't enough because > dwc2_hcd_qh_add() then had code to reset things if the frame _wasn't_ > in the future. There's no reason not to just pick the frame later. > For non-periodic QH we now pick the frame in dwc2_hcd_qh_add(). For > periodic QH we pick the frame at dwc2_schedule_periodic() time. > * The old "dwc2_qh_init() actually assigned to "hsotg->frame_number". > This doesn't seem like a great idea since that variable is supposed to > be used to keep track of which SOF the interrupt handler has seen. > Let's be clean: anyone who wants the current frame number (instead of > the one as of the last interrupt) should ask for it. > * The old code wasn't terribly consistent about trying to use the frame > that the microframe scheduler assigned to it. In > dwc2_sched_periodic_split() when it was scheduling the first frame it > always "ORed" in 0x7 (!). Since the frame goes on the wire 1 uFrame > after next_active_frame it meant that the SSPLIT would always try for > uFrame 0 and the transaction would happen on the low speed bus during > uFrame 1. This is irregardless of what the microframe scheduler > said. > * The old code assumed it would get called to schedule the next in a > periodic split very quickly. That is if next_active_frame was > 0 (transfer on wire in uFrame 1) it assumed it was getting called to > schedule the next uFrame during uFrame 1 too (so it could queue > something up for uFrame 2). It should be possible to actually queue > something up for uFrame 2 while in uFrame 2 (AKA queue up ASAP). To > do this, code needs to look at the previously scheduled frame when > deciding when to next be active, not look at the current frame number. > * If there was no microframe scheduler, the old code would check for > whether we should be active using "qh->next_active_frame == > frame_number". This seemed like a race waiting to happen. ...plus > there's no way that you wouldn't want to schedule if next_active_frame > was actually less than frame number. > > Note that this change doesn't make 100% sense on its own since it's > expecting some sanity in the frame numbers assigned by the microframe > scheduler and (as per the future patch which rewries it) I think that > the current microframe scheduler is quite insane. However, it seems > like splitting this up from the microframe scheduler patch makes things > into smaller chunks and hopefully adds to clarity rather than reduces > it. The two patches could certainly be squashed. Not that in the very > least, I don't see any obvious bad behavior introduced with just this > patch. > > I've attempted to keep the config parameter to disable the microframe > scheduler in tact in this change, though I'm not sure it's worth it. > Obviously the code is touched a lot so it's possible I regressed > something when the microframe scheduler is disabled, though I did some > basic testing and it seemed to work OK. I'm still not 100% sure why you > wouldn't want the microframe scheduler (presuming it works), so maybe a > future patch (or a future version of this patch?) could remove that > parameter. > > Signed-off-by: Douglas Anderson <diand...@chromium.org> > --- > Changes in v5: None > Changes in v4: > - Manage frame nums better in scheduler new for v4. > > Changes in v3: None > Changes in v2: None > > drivers/usb/dwc2/hcd.h | 10 +- > drivers/usb/dwc2/hcd_queue.c | 355 > ++++++++++++++++++++++++++++++++----------- > 2 files changed, 273 insertions(+), 92 deletions(-)
As an FYI to anyone considering reviewing or applying this particular patch. It's proposed to squash <https://chromium-review.googlesource.com/#/c/324185/> as a fixup to this patch for the next version. This is intended to fix problems that Alan Stern reported at <http://www.spinics.net/lists/linux-usb/msg135678.html> -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html