Hello.
On 05/12/2016 09:31 PM, Hans de Goede wrote:
When the board is powering attached usb devices via the otg port
sometimes / on some devices it takes slightly too long for the VBus
I think it's either VBUS or Vbus, not this strange spelling.
detection code in phy-sun4i-usb.c to signal that VBus is high after
enabling VBus and the musb hardware signals a MUSB_INTR_VBUSERROR
interrupt.
This commit sets the otg state to A_WAIT_VRISE upon enabling Vbus
making musb_stage0_irq() ignore the first VBUSERR_RETRY_COUNT
VBUSERROR interrupts, fixing connection issues in these cases.
Signed-off-by: Hans de Goede <hdego...@redhat.com>
---
drivers/usb/musb/sunxi.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/drivers/usb/musb/sunxi.c b/drivers/usb/musb/sunxi.c
index 2c33d9b..2ee48fb 100644
--- a/drivers/usb/musb/sunxi.c
+++ b/drivers/usb/musb/sunxi.c
@@ -112,7 +112,7 @@ static void sunxi_musb_work(struct work_struct *work)
if (test_bit(SUNXI_MUSB_FL_HOSTMODE, &glue->flags)) {
set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
musb->xceiv->otg->default_a = 1;
- musb->xceiv->otg->state = OTG_STATE_A_IDLE;
+ musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE;
MUSB_HST_MODE(musb);
devctl |= MUSB_DEVCTL_SESSION;
} else {
@@ -145,9 +145,10 @@ static void sunxi_musb_set_vbus(struct musb *musb, int
is_on)
{
struct sunxi_glue *glue = dev_get_drvdata(musb->controller->parent);
- if (is_on)
+ if (is_on) {
set_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
- else
+ musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE;
+ } else
clear_bit(SUNXI_MUSB_FL_VBUS_ON, &glue->flags);
CodingStyle, all *if* branches should use {} if one uses {}.
[...]
MBR, Sergei
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
