Hi Kishon,
Am Mittwoch, 29. Juni 2016, 19:44:52 schrieb Kishon Vijay Abraham I:
> On Friday 17 June 2016 10:16 PM, Heiko Stübner wrote:
> > Am Freitag, 17. Juni 2016, 17:24:46 schrieb Kishon Vijay Abraham I:
> > [...]
> >
> >>> + /* find out a proper config which can be matched with dt. */
> >>> + index = 0;
> >>> + while (phy_cfgs[index].reg) {
> >>> + if (phy_cfgs[index].reg == reg) {
> >>
> >> Why not pass these config values from dt? Moreover finding the config
> >> using register offset is bound to break.
> >
> > As you have probably seen, this phy block is no stand-alone
> > (mmio-)device, but gets controlled through special register/bits in the
> > so called "General Register Files" syscon.
> >
> > The values stored and accessed here, are the location and layout of
> > those
> > control registers. Bits in those phy control registers at times move
> > between phy-versions in different socs (rk3036, rk3228, rk3366, rk3368,
> > rk3399) and some are even missing. So I don't really see a nice way to
> > describe that in dt without describing the register and offset of each
> > of those 22 used bits individually.
> >
> >
> > I'm also not sure where you expect it to break? The reg-offset is the
> > offset of the phy inside the GRF and the Designware-phy also already
> > does something similar to select some appropriate values.
>
> I'm concerned the phy can be placed in the different reg-offset within GRF
> (like in the next silicon revision) and this driver can't be used.
That is something that has not happened with all Rockchip SoCs I have had in
my hands so far.
While the GRF is some sort-of wild-west area with settings for vastly
different blocks in there and always changes between different socs (rk3288
[4-core A17] <-> rk3366 <-> rk3368 [8-core A53] <-> rk3399 etc) there
haven't been such changes (different register offsets) between soc-revisions
of the same soc that I know off.
The GRF also includes such important things like the whole pinctrl handling,
so if there were such offset changes in the GRF a lot of drivers (and
maintainers) would get very unhappy - me included :-) .
Heiko
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
