Brian Kim <brian....@hardkernel.com> writes:
> Enable both gxbb USB controller and add a 5V regulator for the OTG port
> VBUS
>
> Signed-off-by: Brian Kim <brian....@hardkernel.com>
Thanks for the patch.
In the future, please state what branch the patch should apply to when
not using mainline. Because of the sd_emmc nodes in your patch, I could
tell that it was based on my integ branch so was able to figure it out,
but it's very helpful to maintainers if you state the branch and/or any
dependencies explicity.
> ---
> .../arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts | 29
> ++++++++++++++++++++++
> 1 file changed, 29 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts
> b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts
> index 8d89edc..997c671 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts
> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts
> @@ -64,6 +64,18 @@
> reg = <0x0 0x0 0x0 0x80000000>;
> };
>
> + usb_pwr: regulator-usb-pwrs {
minor nit: since this is specific to the OTG part, can you call this
usb_otg_pwr? ...
> + compatible = "regulator-fixed";
> +
> + regulator-name = "USB_PWR";
... and rename this also?
> + regulator-min-microvolt = <5000000>;
> + regulator-max-microvolt = <5000000>;
> +
> + gpio = <&gpio_ao GPIOAO_5 GPIO_ACTIVE_HIGH>;
> + enable-active-high;
> + };
> +
Thanks
Kevin
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
