Thanks a lot for you look into this patch, I will fixed these typos.
Best Regards Jerry Huang -----Original Message----- From: Sergei Shtylyov [mailto:sergei.shtyl...@cogentembedded.com] Sent: Friday, November 25, 2016 9:12 PM To: Jerry Huang <jerry.hu...@nxp.com>; st...@rowland.harvard.edu; gre...@linuxfoundation.org Cc: Ramneek Mehresh <ramneek.mehr...@nxp.com>; julia.law...@lip6.fr; Sriram Dash <sriram.d...@nxp.com>; linux-usb@vger.kernel.org; linux-ker...@vger.kernel.org Subject: Re: [PATCH v2] fsl/usb: Workarourd for USB erratum-A005697 Hello. On 11/25/2016 06:24 AM, Changming Huang wrote: > The EHCI specification states the following in the SUSP bit description: > In the Suspend state, the port is senstive to resume detection. Sensitive. > Note that the bit status does not change untile the port is suspended > and Until. > that there may be a delay in susupending a port if there is a > transaction Suspending. > currently in progress on the USB. > > However, in NXP USBDR controller, the PORTSCx[SUSP] bit changes > immediately when the application sets it and not when the port is actually > suspended. > > So the application must wait for at least 10 milliseconds after a port > indicates that it is suspended, to make sure this port has entered > suspended state before initiating this port resume using the Force > Port Resume bit. This bit is for NXP controller, not EHCI compatible. > > Signed-off-by: Changming Huang <jerry.hu...@nxp.com> > Signed-off-by: Ramneek Mehresh <ramneek.mehr...@nxp.com> [...] > diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c > index 74f62d6..81e2310 100644 > --- a/drivers/usb/host/ehci-hub.c > +++ b/drivers/usb/host/ehci-hub.c > @@ -310,6 +310,13 @@ static int ehci_bus_suspend (struct usb_hcd *hcd) > } > spin_unlock_irq(&ehci->lock); > > + if (changed && ehci_has_fsl_susp_errata(ehci)) > + /* Wait for at least 10 millisecondes to ensure the controller Milliseconds. > + * enter the suspend status before initiating a port resume > + * using the Fore Port Resume bit (Not-EHCI compatible). Maybe force? s/Not/non/ also. > + */ > + usleep_range(10000, 20000); > + > if ((changed && ehci->has_tdi_phy_lpm) || fs_idle_delay) { > /* > * Wait for HCD to enter low-power mode or for the bus [...] > @@ -703,10 +704,15 @@ struct ehci_tt { #if defined(CONFIG_PPC_85xx) > /* Some Freescale processors have an erratum (USB A-005275) in which > * incoming packets get corrupted in HS mode > + * Some Freescale processors have an erratum (USB A-005697) in which > + * we need to wait for 10ms for bus to fo into suspend mode after Fo? [...] MBR, Sergei N�����r��y����b�X��ǧv�^�){.n�+����{������^n�r���z���h�����&�� �G���h�(�階�ݢj"���m������z�ޖ���f���h���~�m�
