Hi, i'm trying to write an hotplug event for an uvc device. Basically i need to start a streaming server (mjpg-streamet) when an uvc device is plugged.
So far the only way i could figure it out was to have a list of VID:PID anche check if the $PRODUCT variable is in that list. This is ok, but since I'm using this software with OpenWRT on an embedded platform i would like to avoid using this device list file. Is there a way to understand that an uvc device has been plugged from with an hotplug event? If there is no way, where can I find an always updated list of supported devices. I know about the one in the home page but i was wondering if there is a similar list in the official distribution. Thanks. -- -------------------------------------------------------- Roberto Riggio, PhD CREATE-NET, Pervasive Researcher Via alla Cascata 56/D - 38100 Povo Trento (Italy) e-mail: [email protected] Tel: (+39) 0461 408400 - interno/extension 708 Fax: (+39) 0461 421157 http://www.create-net.org/ -------------------------------------------------------- Le informazioni contenute in questo messaggio email e negli allegati sono strettamente riservate. Il loro utilizzo e' consentito esclusivamente al destinatario del messaggio, per le finalita' indicate nello stesso. The information transmitted is intended only for the person/entity whom it is addressed to, and may contain confidential material. Any review, retransmission, dissemination or other use of this information by persons/entities other than the intended recipient is prohibited as per Italian Law 196/2003. If you received this in error, contact the sender and delete it from any pc. _______________________________________________ Linux-uvc-devel mailing list [email protected] https://lists.berlios.de/mailman/listinfo/linux-uvc-devel
