On 02/17/2015 08:43 AM, Larry Finger wrote:
On 02/17/2015 02:29 AM, Alan Fisher wrote:
Larry,
I am guessing that you have an RTL8188CE, which uses rtl8192ce.
Yep, my wireless card is an RTL8188CE
The purpose of rtl_is_special_data() is to ensure that management
packets have
the highest probability of being successfully transmitted by sending
them at a
low rate.
...
It also occurs to me that mac80211 probably handles this function,
and that it
may be possible to remove this routine, which is essentially what your
workaround does.
I couldn't find any information on mac80211 treating certain packets
(ARP, DHCP,
etc...) as special. It does seem to handle automatic rate selection,
though. I
would think that would be enough to handle packet loss reasonably
well. I
believe the protocols tested for here all have mechanisms for
handling lost
packets. I also can't find any other 802.11 drivers which try to
handle DHCP
packets in a special way. I think it would be safe to remove this
routine. I
have a patch to do that, if you're okay with that change.
The story is a bit more complicated. These drivers use firmware rate
selection, not the ones in mac80211. At this point, I would not be
comfortable with removing the entire routine.
Ok, makes sense.
Regarding the patch, this change:
- } else if (0x86DD == ether_type) {
- return true;
}
successfully prevents IPv6 packets from being treated as special (and
thus
dropped).
However, this:
+ if (ETH_P_IP == ether_type || ETH_P_IPV6 == ether_type) {
ip = (struct iphdr *)((u8 *)skb->data + offset +
seems to be reading an IPv4 header (struct iphdr) from an IPv6
packet. I believe
a struct ipv6hdr should be used here.
You are correct. My patch was prepared too hastily.
If we are to continue handling certain types of packets differently,
IPv6
neighbor solicitation messages (like ARP in IPv4) and IPv6 router
discovery
messages (stateless IPv6 autoconfig, similar to DHCP in IPv4
networks) should
probably be added to the list to maintain consistency with what is
being handled
for IPv4. These are both variants of ICMPv6 packets, although generally
transmitting all ICMPv6 packets at the lowest rate is probably a bad
idea, as
ICMP echo is commonly used to measure network performance and should
be treated
the same as normal traffic.
For the moment, I think we need to return false, not true, for all
IPv6 packets until a more complete solution is found. Does the
attached patch fix the problem you are seeing? I do not have an IPv6
compliant ISP, thus I cannot do much testing.
Yes, IPv6 appears to work normally with that patch applied. I recently
spoke with someone who uses RTL8188 under Linux 3.18, and doesn't see
any packet loss with special packets. I would guess this is because he
has a slightly different hardware configuration (different processor,
etc..).
Larry
Thanks,
Alan
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
