On 06/03/2015 07:47 PM, Taehee Yoo wrote:
After physical reconnect, the rtl8192cu chipset shows low
transmission rates.It cause is that variable "iqk_initialized"
do not de-initialized. So I add this code.
Signed-off-by: Taehee Yoo <ap420...@gmail.com>
---
drivers/net/wireless/rtlwifi/rtl8192cu/hw.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
I like this patch very much. Getting rid of a static variable is always good.
Acked-by: Larry Finger <larry.fin...@lwfinger.net>
Thanks,
Larry
diff --git a/drivers/net/wireless/rtlwifi/rtl8192cu/hw.c
b/drivers/net/wireless/rtlwifi/rtl8192cu/hw.c
index 1898596..6a4ef05 100644
--- a/drivers/net/wireless/rtlwifi/rtl8192cu/hw.c
+++ b/drivers/net/wireless/rtlwifi/rtl8192cu/hw.c
@@ -987,7 +987,6 @@ int rtl92cu_hw_init(struct ieee80211_hw *hw)
struct rtl_phy *rtlphy = &(rtlpriv->phy);
struct rtl_ps_ctl *ppsc = rtl_psc(rtl_priv(hw));
int err = 0;
- static bool iqk_initialized;
unsigned long flags;
/* As this function can take a very long time (up to 350 ms)
@@ -1038,11 +1037,11 @@ int rtl92cu_hw_init(struct ieee80211_hw *hw)
rtlpriv->cfg->ops->set_hw_reg(hw, HW_VAR_ETHER_ADDR, mac->mac_addr);
if (ppsc->rfpwr_state == ERFON) {
rtl92c_phy_set_rfpath_switch(hw, 1);
- if (iqk_initialized) {
+ if (rtlphy->iqk_initialized) {
rtl92c_phy_iq_calibrate(hw, true);
} else {
rtl92c_phy_iq_calibrate(hw, false);
- iqk_initialized = true;
+ rtlphy->iqk_initialized = true;
}
rtl92c_dm_check_txpower_tracking(hw);
rtl92c_phy_lc_calibrate(hw);
@@ -1391,6 +1390,9 @@ void rtl92cu_card_disable(struct ieee80211_hw *hw)
_CardDisableHWSM(hw);
else
_CardDisableWithoutHWSM(hw);
+
+ /* after power off we should do iqk again */
+ rtlpriv->phy.iqk_initialized = false;
}
void rtl92cu_set_check_bssid(struct ieee80211_hw *hw, bool check_bssid)
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html