On Wednesday 05 August 2015 05:51 PM, Felix Fietkau wrote:
On 2015-07-21 13:36, Vasanthakumar Thiagarajan wrote:
Add vendor/device id of QCA99X0 V2.0 to pci id table and
QCA99X0_HW_2_0_CHIP_ID_REV to ath10k_pci_supp_chips[] for
QCA99X0 to get detected by the driver.
Signed-off-by: Vasanthakumar Thiagarajan <vthia...@qti.qualcomm.com>
I just tested a 99X0 card, and I'm getting this:
[ 8.742514] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142)
[ 8.747173] ath10k_pci 0000:01:00.0: pci irq msi interrupts 1 irq_mode 0
reset_mode 0
[ 11.793314] ath10k_pci 0000:01:00.0: failed to receive initialized event
from target: 00000000
[ 11.793344] ath10k_pci 0000:01:00.0: failed to wait for target after cold
reset: -110
[ 11.800814] ath10k_pci 0000:01:00.0: failed to reset chip: -110
[ 11.809228] ath10k_pci: probe of 0000:01:00.0 failed with error -110
This is on an AP148 board with Linux 3.18, backports generated from
latest wireless-testing (2015-08-03) + all patches from kvalo's ath
tree.
Any idea about the version of AP148 that you are using?. By any chance did
you check if QCA988X is working on the same board?.
Vasanth
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
