On 16 September 2016 at 12:56, Matteo Grandi <grn.mat...@gmail.com> wrote: > Hello all, [...] > [ 8.589474] ath10k_pci 0000:07:00.0: qca988x hw2.0 (0x4100016c, > 0x043222ff sub 0000:0000) fw 10.2.4.70.54 fwapi 5 bdapi 1 htt-ver 2.1 > wmi-op 5 htt-op 2 cal otp max-sta 128 raw 0 hwcrypto 1 features > no-p2p,raw-mode
The "raw-mode" here only hints the firmware is capable of raw mode operation which needs to be explicitly enabled. > [ 8.589491] ath10k_pci 0000:07:00.0: debug 1 debugfs 1 tracing 0 > dfs 0 testmode 1 > [ 8.691670] ath: EEPROM regdomain: 0x0 > [ 8.691680] ath: EEPROM indicates default country code should be used > [ 8.691686] ath: doing EEPROM country->regdmn map search > [ 8.691695] ath: country maps to regdmn code: 0x3a > [ 8.691702] ath: Country alpha2 being used: US > [ 8.691706] ath: Regpair used: 0x3a > [ 176.983250] ath10k_pci 0000:07:00.0: must load driver with > rawmode=1 to add mesh interfaces [...] > - I've also tried to load the ath10k modules adding the parameter > rowmode=1 but I had an error "rawmode unknown parameter" Only ath10k_core needs to be loaded with rawmode=1. You can check available module parameters with: modinfo ath10k_core modinfo ath10k_pci Michał
