On 8-2-2017 10:29, Paolo Abeni wrote: > On Wed, 2017-02-08 at 09:52 +0100, Rafał Miłecki wrote: >> On 8 February 2017 at 09:38, Paolo Abeni <pab...@redhat.com> wrote: >>> On Tue, 2017-02-07 at 20:23 +0100, Arend Van Spriel wrote: >>>> On 7-2-2017 17:50, Paolo Abeni wrote: >>>>> the skbs can be held by the driver for a long time, so we need >>>>> to clear any state on xmit to avoid hanging other subsystems. >>>>> The skbs are already orphaned later in cmsg code, so we just >>>>> need to clear the nf/dst/secpath. >>>>> Do it early, while the relevant entries are hopefully still >>>>> hot in the cache. >>>> >>>> What is this about really? A bit more background about the issue >>>> might >>>> help understanding the need for this patch. Is this really >>>> specific >>>> to >>>> brcmfmac. For instance is something similar already done in >>>> mac80211? >>> >>> The issue is apparently driver specific, as reported in: >>> >>> https://bugzilla.redhat.com/show_bug.cgi?id=1294415 >>> >>> This is caused by xmit skbs carrying a notrack ct entry not being >>> freed >>> by the device driver in a timely manner. Removing the ct module >>> waits >>> for such entries refcount going to zero and hangs the kernel in >>> busy >>> loop (for several minutes). >>> >>> The relevant skbs are icmp6 packets (ND if I recall correctly, they >>> bcast packets at the mac level). >>> >>> The only other known device driver suffering for the issue is the >>> infiniband ipoib driver, I send a separate patch for it. >>> >>> I lack the broadcom h/w, but with infiniband the bug can be >>> reproduced >>> with the following steps: >>> >>> - ensure ipv6 is enabled on the target device, and firewalld is >>> running >>> (e.g. the module nf_conntrack_ipv6 is loaded) >>> - assign a static ip to the device >>> - shut down the firewall (e.g. try to remove the module >>> nf_conntrack) >>> >>> For the brcmfmac driver most probably it is necessary being >>> disassociated from the AP before shutting down the firewall (but I >>> can't double check). This is probably why mac80211 does not suffer >>> this >>> issue. >>> >>> The root cause for the issue could be actually a firmware issue, >>> any >>> better clues are more than welcome! >> >> Do I get this correctly brcmfmac gets some skb for transmitting it >> and >> doesn't free it for few minutes? It sounds like some bug that should >> be fixed instead of hiding it. > > I mostly agreed, but please also note that early clearing the skb head > state makes sense from a performance pov: we can do the costly, > required, atomic operations while the data is still hot in the cpu L1 > cache. > > I'm unable to find anything obvious at the driver level, and I think > the root cause could be in the firmware. I hope some more knowledgeable > than me on this topics can have a better look.
Hi Paolo, I agree with Rafał that several minutes for an skb to be freed is a red flag. Now I know our driver and firmware but not played to much with IPv6 and firewalls. Hopefully I have all the netfilter stuff in my kernel when I try to reproduce it over here. Regards, Arend