Am 09.06.2017 um 15:50 schrieb Ben Greear:
On 06/09/2017 04:07 AM, Sven Eckelmann wrote:
From: Ben Greear <gree...@candelatech.com>
The ath10k firmware doesn't announce its VHT channel width
capabilities in
the vht_cap information from the "service ready event" arguments. The
driver must therefore check whether the 160MHz short GI bit is set and
whether the driver still doesn't set the bits for the 160/80+80 MHz
capabilities.
The two bits for the channel width are a two bit integer and not two
separate bits which cannot be parsed without the knowledge of the other
bit. Using IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ (b10..)
as a
mask for this task doesn't make any sense. The correct mask for the VHT
channel width should be used instead to make this check more readable.
I didn't test them, but a quick review looks good. Thanks for picking
this up!
mmh except that it wont change anything. this patch is a workaround for
older firmwares. these older firmwares have this flag zeroed
newer firmwares have 80p80 set. thats all. for sure we can now check if
the mask is 0 or not 0. but it wont change anything at the end
--Ben
--
Mit freundlichen Grüssen / Regards
Sebastian Gottschall / CTO
NewMedia-NET GmbH - DD-WRT
Firmensitz: Berliner Ring 101, 64625 Bensheim
Registergericht: Amtsgericht Darmstadt, HRB 25473
Geschäftsführer: Peter Steinhäuser, Christian Scheele
http://www.dd-wrt.com
email: s.gottsch...@dd-wrt.com
Tel.: +496251-582650 / Fax: +496251-5826565
