Hi
Im trying to get wds working. I haven’t found much documentation on this topic.
This is what i have found:
https://wireless.wiki.kernel.org/en/users/documentation/iw#setting_up_a_wds_peer
I have configured two machines with hostapd with the same config. Its also the
same wifi card WLE200NX using the AR9280 chipset.
After APs is running I have used this commands on both AP’s with the other APs
wifi mac address:
iw phy phy0 interface add wds0 type wds
iw dev wds0 set peer <MAC address>
then wds0 interface is showing up
------------------
wds0 IEEE 802.11abgn Mode:Repeater Access Point: Not-Associated
Tx-Power=20 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:off
---------------------
But it says Access Point: Not-Associated
I have no clue what to do next.
Is there anyone who know something about this?
Thank you for any help
Best Regards,
Håvard Rabbe
