On 2018-03-28 13:36, Johannes Berg wrote:
On Wed, 2018-03-28 at 10:24 +0530, vthia...@codeaurora.org wrote:
> The question is how that interacts with having enough space - are you
> sure this is a concern?
This will not be an issue at lest for ath10k. This is mainly for a
(new)driver
which implements the offload but has limitation in supporting more
than
certain
number of peers. Perhaps we can remove it now and add it when such
driver is
available?
Ok, that's good. Yes, I think that sounds better - I have a hard time
imagining a firmware/driver that has space for the station, but doesn't
automatically allocate a u16 bitmap as part of the station :-)
> > * @NL80211_CMD_SET_NOACK_MAP: sets a bitmap for the individual TIDs
> > whether
> > - * No Acknowledgement Policy should be applied.
> > + * No Acknowledgement Policy should be applied. %NL80211_ATTR_MAC is
> > used
> > + * to apply No Acknowledgement policy for a particular connected
> > station.
> > + * Station specific NoAck policy configuration is valid only for
> > STA's
> > + * current connection, i.e. the configuration will not be used when
> > the
> > + * station connects back after disconnection/roaming.
> > + * When user-space does not include %NL80211_ATTR_MAC, the No
> > + * Acknowledgement Policy setting should be treated as per-netdev
> > + * configuration.
>
> Here you describe different semantics - i.e. you didn't describe the
> "previous per-station settings are kept" part. I'm not sure that part
> makes much sense anyhow?
Not sure I got this comment right. As mentioned in the doc, the
previous
settings
would be reset upon reconnection of the station and any ndev wide
configuration
will be used. As mentioned above, additionally default value will be
set
to the
station to mark no per-station configuration is given so far.
I just thought that there was a difference in how this applies to a
certain station.
May be the doc needs more update
Btw, we should probably also have a way to *delete* the per-station
configuration, so it uses the default again?
Sure. How about setting it to default when the command is received with
no
NL80211_ATTR_NOACK_MAP attribute for a station?
Vasanth
