> >
> > 8< ------------------------
> > diff --git a/drivers/net/wireless/ti/wlcore/main.c
> > b/drivers/net/wireless/ti/wlcore/main.c
> > --- a/drivers/net/wireless/ti/wlcore/main.c
> > +++ b/drivers/net/wireless/ti/wlcore/main.c
> > @@ -1867,8 +1867,6 @@ static int __maybe_unused
> > wl1271_op_resume(struct ieee80211_hw *hw)
> > if (ret)
> > wl12xx_queue_recovery_work(wl);
> > }
> > -
> > - wlcore_enable_interrupts(wl);
> > }
> >
> > if (pending_recovery) {
> > @@ -1877,6 +1875,8 @@ static int __maybe_unused
> > wl1271_op_resume(struct ieee80211_hw *hw)
> > goto out_sleep;
> > }
> >
> > + wlcore_enable_interrupts(wl);
> > +
> > ret = pm_runtime_get_sync(wl->dev);
> > if (ret < 0) {
> > pm_runtime_put_noidle(wl->dev);
>
> It still crash.
> The crash is different now.
> It also complains about:
> [ 60.544224] Unbalanced enable for IRQ 65
> Need down/up of the interface to recover after it.
> Log below:
>
Actually the below patch removing the call to wlcore_fw_sleep() avoids this
error.
The downside is that the wl8 firmware remains fully active during supend, so we
Would need to find the root cause why the last call allowing the wilink8
firmware
To go into ELP mode during suspend is only completing on resume and not during
Suspend enter.
diff --git a/drivers/net/wireless/ti/wlcore/main.c
b/drivers/net/wireless/ti/wlcore/main.c
index 4c297aa..8df1ae6 100644
--- a/drivers/net/wireless/ti/wlcore/main.c
+++ b/drivers/net/wireless/ti/wlcore/main.c
@@ -1789,7 +1789,6 @@ static int wl1271_op_suspend(struct ieee80211_hw *hw,
goto out_sleep;
out_sleep:
- pm_runtime_put_noidle(wl->dev);
mutex_unlock(&wl->mutex);
if (ret < 0) {
@@ -1821,15 +1820,7 @@ static int wl1271_op_suspend(struct ieee80211_hw *hw,
*/
cancel_delayed_work(&wl->tx_watchdog_work);
- /*
- * Use an immediate call for allowing the firmware to go into power
- * save during suspend.
- * Using a workque for this last write was only hapenning on resume
- * leaving the firmware with power save disabled during suspend,
- * while consuming full power during wowlan suspend.
- */
- wlcore_fw_sleep(wl);
-
+ pm_runtime_put_noidle(wl->dev);
return 0;
}
With this wowlan seems to work ok and suspend/resume is not crashing when
enabling wowlan. See below:
root@am335x-evm:/usr/share/wl18xx#
root@am335x-evm:/usr/share/wl18xx#
root@am335x-evm:/usr/share/wl18xx#
root@am335x-evm:/usr/share/wl18xx# iw phy0 wowlan enable any
root@am335x-evm:/usr/share/wl18xx#
root@am335x-evm:/usr/share/wl18xx# echo mem > /sys/power/state
[ 63.794805] PM: suspend entry (deep)
[ 63.798455] PM: Syncing filesystems ... done.
[ 65.779673] Freezing user space processes ... (elapsed 0.001 seconds) done.
[ 65.788878] OOM killer disabled.
[ 65.792117] Freezing remaining freezable tasks ... (elapsed 0.001 seconds)
done.
[ 65.801196] Suspending console(s) (use no_console_suspend to debug)
[ 65.952459] pm33xx pm33xx: PM: Successfully put all powerdomains to target
state
[ 65.952459] PM: Wakeup source GPIO0
[ 65.977028] net eth0: initializing cpsw version 1.12 (0)
[ 66.074419] SMSC LAN8710/LAN8720 4a101000.mdio:00: attached PHY driver [SMSC
LAN8710/LAN8720] (mii_bus:phy_addr=4a101000.mdio:00, irq=POLL)
[ 66.236312] OOM killer enabled.
[ 66.239604] Restarting tasks ... done.
[ 66.282501] PM: suspend exit
root@am335x-evm:/usr/share/wl18xx#
BR,
Eyal
