The MRF24J40MC module has an external amplifier which should be enabled.

Signed-off-by: Simon Vincent <simon.vinc...@xsilon.com>
---
 drivers/net/ieee802154/mrf24j40.c | 40 +++++++++++++++++++++++++++++++++++++--
 1 file changed, 38 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ieee802154/mrf24j40.c 
b/drivers/net/ieee802154/mrf24j40.c
index 9e6a124..7950d01 100644
--- a/drivers/net/ieee802154/mrf24j40.c
+++ b/drivers/net/ieee802154/mrf24j40.c
@@ -43,6 +43,8 @@
 #define REG_TXSTBL   0x2E  /* TX Stabilization */
 #define REG_INTSTAT  0x31  /* Interrupt Status */
 #define REG_INTCON   0x32  /* Interrupt Control */
+#define REG_GPIO     0x33  /* GPIO */
+#define REG_TRISGPIO 0x34  /* GPIO direction */
 #define REG_RFCTL    0x36  /* RF Control Mode Register */
 #define REG_BBREG1   0x39  /* Baseband Registers */
 #define REG_BBREG2   0x3A  /* */
@@ -63,6 +65,7 @@
 #define REG_SLPCON1    0x220
 #define REG_WAKETIMEL  0x222  /* Wake-up Time Match Value Low */
 #define REG_WAKETIMEH  0x223  /* Wake-up Time Match Value High */
+#define REG_TESTMODE   0x22F  /* Test mode */
 #define REG_RX_FIFO    0x300  /* Receive FIFO */
 
 /* Device configuration: Only channels 11-26 on page 0 are supported. */
@@ -75,6 +78,8 @@
 #define RX_FIFO_SIZE 144 /* From datasheet */
 #define SET_CHANNEL_DELAY_US 192 /* From datasheet */
 
+enum modules { MRF24J40, MRF24J40MA, MRF24J40MC };
+
 /* Device Private Data */
 struct mrf24j40 {
        struct spi_device *spi;
@@ -690,6 +695,35 @@ static int mrf24j40_hw_init(struct mrf24j40 *devrec)
        if (ret)
                goto err_ret; 

+       if (spi_get_device_id(devrec->spi)->driver_data == MRF24J40MC) {
+               /* Enable external amplifier */
+               ret = write_long_reg(devrec, REG_TESTMODE, 0xF);
+               if (ret)
+                       goto err_ret;
+
+               ret = read_short_reg(devrec, REG_TRISGPIO, &val);
+               if (ret)
+                       goto err_ret;
+
+               val |= 0x8;
+               ret = write_short_reg(devrec, REG_TRISGPIO, val);
+               if (ret)
+                       goto err_ret;
+
+               ret = read_short_reg(devrec, REG_GPIO, &val);
+               if (ret)
+                       goto err_ret;
+
+               val |= 0x8;
+               ret = write_short_reg(devrec, REG_GPIO, val);
+               if (ret)
+                       goto err_ret;
+
+               ret = write_long_reg(devrec, REG_RFCON3, 0x28);
+               if (ret)
+                       goto err_ret;
+       }
+
        return 0;
 
 err_ret:
@@ -778,8 +813,9 @@ static int mrf24j40_remove(struct spi_device *spi)
 }
 
 static const struct spi_device_id mrf24j40_ids[] = {
-       { "mrf24j40", 0 },
-       { "mrf24j40ma", 0 },
+       { "mrf24j40", MRF24J40 },
+       { "mrf24j40ma", MRF24J40MA },
+       { "mrf24j40mc", MRF24J40MC },
        { },
 };
 MODULE_DEVICE_TABLE(spi, mrf24j40_ids);
-- 
1.9.1


------------------------------------------------------------------------------
Infragistics Professional
Build stunning WinForms apps today!
Reboot your WinForms applications with our WinForms controls. 
Build a bridge from your legacy apps to the future.
http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk
_______________________________________________
Linux-zigbee-devel mailing list
Linux-zigbee-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linux-zigbee-devel

Reply via email to