On Tue, 7 Jan 2003, GOMES Rui Pedro wrote:
>
> There are, already, some printers attached. Most of them are attached
> through Windows Client Access. If I order a print to a printer, lets call it
> Client Access (CA) printer, and then release the job, it prints without any
> more intervention. But that same printer, started through lp5250d, gives the
> paper msg. Even if I order the print to the CA printer and, on the spool
> changing the queue atributes to print on the lp5250d printer, it gives the
> same msg.
On my system, it gives the 'Load form type *STD into printer XXX' message
the first time I print to it. I answer that message with a G, and it
does not ask again.
>
> Meanwhile do you have any more sugestions?
>
Not really. I'm using a very similar set-up here, and I don't seem to
have the same problem.
Here's my config:
PI {
env.DEVNAME = pi
host = as400
env.IBMMFRTYPMDL = *HP4
outputcommand = scs2ascii|lpr -Ppi
env.IBMMSGQNAME=W3
env.IBMMSGQLIB=*LIBL
}
The only difference I see, aside from the name of the printer, is
that I'm telling it which message queue to send the messages to.
But, if I remove those entries, I still don't have any problems.
I've tried it with both version 0.16.5 and 0.17.1 (from CVS) and
both work flawlessly for me.
_______________________________________________
This is the Linux 5250 Development Project (LINUX5250) mailing list
To post a message email: [EMAIL PROTECTED]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo.cgi/linux5250
or email: [EMAIL PROTECTED]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/linux5250.
