Debes configurar solo un default gateway que en tu caso seria la 10.10.5.1 Que distribución usas????
El mié, 19-05-2004 a las 11:58, [EMAIL PROTECTED] escribió: > Hola a todos: Tengo el siguiente problema. > En mi pc tengo instaladas 2 tarjetas de red(eth0 = realtek OK y eth1 = dlink > que > la reconoce como via rine) > > la eth0 pertenecea a esta red > eth0 Link encap:Ethernet HWaddr 00:0D:88:18:82:C6 > inet addr:10.10.5.172 Bcast:10.10.5.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:126198 errors:0 dropped:0 overruns:0 frame:0 > TX packets:83862 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 > RX bytes:132770449 (126.6 MiB) TX bytes:7451569 (7.1 MiB) > > y la eth1 a esta red > eth1 Link encap:Ethernet HWaddr 00:E0:7D:F1:D0:02 > inet addr:10.20.58.120 Bcast:10.20.255.255 Mask:255.255.0.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:509 errors:0 dropped:0 overruns:0 frame:0 > TX packets:89 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 > RX bytes:50688 (49.5 KiB) TX bytes:8738 (8.5 KiB) > > el problema es que despues de un rato o de un /etc/init.d/netwoerking restart > quedo con 0% de comunicacion > > > el route me dice > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use Iface > localnet * 255.255.255.0 U 0 0 0 eth0 > 10.20.0.0 * 255.255.0.0 U 0 0 0 eth1 > default 10.10.5.1 0.0.0.0 UG 0 0 0 eth0 > > > despues de un /etc/init.d/networking restart el route me dice > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use Iface > localnet * 255.255.255.0 U 0 0 0 eth0 > 10.20.0.0 * 255.255.0.0 U 0 0 0 eth1 > default 10.20.1.1 0.0.0.0 UG 0 0 0 eth1 > default 10.10.5.1 0.0.0.0 UG 0 0 0 eth0 > > mi salida a internt es por el 10.10.5.1 > > > eso no + gracias a todos > > > ------------------------------------------------- > This mail sent through IMP: http://mail.articlynx.cl/