On Sun, Mar 22, 2009 at 4:51 PM, Albeiro Caucali Mayorga <albeir...@hotmail.com> wrote: > > Más datos. ¿qué conexión tienes, ADSL, Cable modem? > > Tengo una conexión ADSL > > ¿Conectas por USB, Ethernet? > > Tengo una tarjeta de red ( ethernet) > > ¿Qué es lo que no funciona? > > No funciona el ingreso a internet, ya que no he podido configurar la cuenta ( > usuario y contraseña), aparece un icono en la barra, con un "chulito" que > dice: "la red está activa en la interfaz eth0 > Dirección IP: 192.... > Pasarela: 192...." > > > > SALIDA PARA: /sbin/ifconfig" > > > eth0 Link encap:Ethernet HWaddr 00:1E:90:8A:62:C8 > inet addr:192.168.1.20 Bcast:192.168.1.255 Mask:255.255.255.0 > inet6 addr: fe80::21e:90ff:fe8a:62c8/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:75 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:8170 (7.9 KiB) > Interrupt:19 Base address:0x6000 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:48 errors:0 dropped:0 overruns:0 frame:0 > TX packets:48 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:3632 (3.5 KiB) TX bytes:3632 (3.5 KiB) > > > > > SALIDA PARA: /sbin/route -n" > > > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use Iface > 192.168.1.0 0.0.0.0 255.255.255.0 U 5 0 0 eth0 > 169.254.0.0 0.0.0.0 255.255.0.0 U 5 0 0 eth0 > 0.0.0.0 192.168.1.1 0.0.0.0 UG 5 0 0 eth0 > > > > SALIDA PARA: pppoeconf: (como admon) > > bash: pppoeconf: command not found > > > _________________________________________________________________ > Explore the seven wonders of the world > http://search.msn.com/results.aspx?q=7+wonders+world&mkt=en-US&form=QBRE
La tarjeta está configurada, pero para la red Interna, que es la que crea el router. Para configurar internet, puedes ir al Centro de Control -> Redes e Internet -> Configurar nuevo interfaz de red y sigue los pasos. En consola puedes usar adsl-setup, como root. Salu2! -- Diego Bello Carreño