Eric, It can be compiled with you new code. But it meet problems in Etherboot stage. In S2880 has two broadcom NIC port in 8131 bus B, and one amd 8111 built-in nic, and even if I hide it in amd8111 init and Etherboot can find it and try to enable it and can not find the PM cap so aborting, in the old linuxbios code (before yesterday) ( with mem hard code), it will go to tickle on Broadcom nic, but in the new code (yesterday check in) ( mem configurable), it will go to MB restarting.???
How about arima broadcom nic position? Regards Yinghai Lu -----邮件原件----- 发件人: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] 发送时间: 2003年7月21日 18:33 收件人: YhLu 抄送: ron minnich; Stefan Reinauer; [EMAIL PROTECTED] 主题: Re: K8 + 2.4.21 + Tyan S2880 YhLu <[EMAIL PROTECTED]> writes: > Eric, > > In the auto.c, if I enable : sdram_initialize(&cpu1), the linuxbios need > another 20k. What happened? Only add one line and the same function has been > called ??? All functions are inline and the set of functions called is large. At least I believe that is the issue. And good luck catching up.... While I am away you get a chance. My latest code has changed sdram_initialize one more time to take a cpu count parameter. And perversely this should help because if a function is called in a loop it will only be inlined once instead of multiple times. Eric _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios