Can you email me the log. Since I don't have epia right, reading the log is the best I can do.
-Andrew On Thu, Oct 02, 2003 at 09:45:53AM -0600, ron minnich wrote: > On Thu, 2 Oct 2003, Andrew Ip wrote: > > > Hi, > > > > Kevin did this fine job in v1. Basically it assigns irqs for PCI devices > > in case of PIRQ table doesn't work. I have been using in different > > place. I also think it would be nice to do it in config file instead > > of in source just like geode. Ron, does epia work now? > > > > I'm not getting any ethernet interrupts. The packets get out, they get > responsded to, but the node never gets the interrupt. > > Also, I get these messages after a while: > eth0: Transmit timed out, status 1003, PHY status 786d, resetting... > > > > I assume this means no TX IRQ. Blast. What do I look for? > > ron > -- Andrew Ip Email: [EMAIL PROTECTED] Tel: (852) 2542 2046 Fax: (852) 2542 2036 Mobile: (852) 9201 9866 Cwlinux Limited Unit 202B 2/F Lai Cheong Factory Building, 479-479A Castle Peak Road, Lai Chi Kok, Kowloon, Hong Kong. For public pgp key, please obtain it from http://www.keyserver.net/en. _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios