On Thu, Jun 03, 2004 at 09:44:56AM -0600, ron minnich wrote: > On Thu, 3 Jun 2004, Erik Smit wrote: > > > Well, the EPIA has a vt8231 southbridge where this board has a vt82c686. > > Won't this give problems? > > There used to be 8231 support. If think they are similar enough it could > work.
I just tried to build freebios2/targets/via/epia by running buildtarget on it and then running make. This is on the cvs of today. I got the following error: /opt/linuxbios/freebios2/src/arch/i386/boot/pirq_routing.c: In function `check_pirq_routing_table': /opt/linuxbios/freebios2/src/arch/i386/boot/pirq_routing.c:21: error: assignment of read-only variable `intel_irq_routing_table' /opt/linuxbios/freebios2/src/arch/i386/boot/pirq_routing.c:42: error: assignment of read-only member `checksum' make[1]: *** [pirq_routing.o] Error 1 I just commented these two lines out since they only appear to be used when something is broken. Then it compiled fine. Then I flashed in the resulting linuxbios.bin using uniflash since flash_and_burn doesn't support the AMIC A29002 chip on this board. Still, after rebooting, nothing appears on the serial port. Can I conclude from this that this board is not yet supported (out of the box)? Is there anything else I can try or maybe help debug the problem? Regards, Erik Smit _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios