You may remove .enable = amd8111_enable, It will be called twice. One in enable_dev.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: Thursday, October 21, 2004 10:46 AM To: YhLu; Li-Ta Lo Cc: LinuxBIOS Subject: Re: Freebios2 recovery progress... Li-Ta Lo <[EMAIL PROTECTED]> writes: > How did you do that ? Where do you put those IDs ? YhLu <[EMAIL PROTECTED]> writes: > You changes all mb config for AMD/Iwill/IBM....that took some time. > > If there is on board scsi, I want to set subsystem id, I need to put that in > Config.lb? Or more likely src/mainboarod/???/???/Options.lb src/devices/pci_device.c:pci_dev_enable_resources() calls dev->ops->pci_ops->set_subsystem() when the device dev->on_mainboard is true. In turn config.g sets that in static.c for all devices in the static tree. I believe those are the correct semantics. That the subsystem is essentially an identifier for the board the chips are sitting on. The values are come from: Look at MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID and MAINBOARD_SUBSYSTEM_DEVICE_ID. So for the onboard scsi case you likely need to have a driver for the onboard scsi device that implements the set_subsystem method because there is not a generic way of doing that. Eric _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios