On Thu, 2005-01-13 at 20:00, YhLu wrote: > I would change dev_initalize to following > void dev_initialize(void) > { > struct device *dev; > > printk_info("Initializing devices...\n"); > #if CONFIG_CONSOLE_VGA == 1 > for (dev = all_devices; dev; dev = dev->next) { > if (dev->enabled && !dev->initialized && > dev->ops && dev->ops->init) > { > if( dev->on_mainboard && (dev->rom_address!=0)) > continue; > printk_debug("%s init\n", dev_path(dev)); > dev->initialized = 1; > dev->ops->init(dev); > } > } > #endif > for (dev = all_devices; dev; dev = dev->next) { > if (dev->enabled && !dev->initialized && > dev->ops && dev->ops->init) > { > printk_debug("%s init\n", dev_path(dev)); > dev->initialized = 1; > dev->ops->init(dev); > } > } > printk_info("Devices initialized\n"); > } >
If we really have to do that, I think we should change the init order to "top to down" instead of "first to last" in the device tree. Ollie > -----Original Message----- > From: YhLu > Sent: Thursday, January 13, 2005 6:51 PM > To: Li-Ta Lo > Cc: Sagiv Yefet; LinuxBIOS > Subject: RE: Running with VGA > > It seems after if after cpu init do the onboard vga init, it will work. > > The CPU init only do the init ECC and clear that after 1M. ... Werid! And it > is not wiped out after power off. > > > YH > > -----Original Message----- > From: Li-Ta Lo [mailto:[EMAIL PROTECTED] > Sent: Thursday, January 13, 2005 3:15 PM > To: YhLu > Cc: Sagiv Yefet; LinuxBIOS > Subject: RE: Running with VGA > > On Thu, 2005-01-13 at 16:23, YhLu wrote: > > S2892 has onboard atirage xl > > S2895 has no onboard. > > > > With exactly the same chip and BIOS? Then probably the order > of calling device::init() does matter. > > Ollie > > > -----Original Message----- > > From: Li-Ta Lo [mailto:[EMAIL PROTECTED] > > Sent: Thursday, January 13, 2005 3:10 PM > > To: YhLu > > Cc: Sagiv Yefet; LinuxBIOS > > Subject: RE: Running with VGA > > > > On Thu, 2005-01-13 at 15:45, YhLu wrote: > > > No, no problem. > > > > > > Same addon card (ati rage xl) (pci) on S2895 works well. > > > > > > > I am confused. Are you using S2895 or S2892? And is the rage xl > > on board or as an addon card? > > > > Ollie > > > _______________________________________________ > Linuxbios mailing list > Linuxbios@clustermatic.org > http://www.clustermatic.org/mailman/listinfo/linuxbios _______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios