Hi, Mondrian, Thanks very much! I works now! I found that the function has not been called before I did some modifications: 1 add a option to the flashrom command line, such as: -m iwill:dk8_htx 2 I comment the pci device search in the board_match_linuxbios_name function because it seems that I can't find the pci device which we add into the board_pciid_enables table. Perhaps I should modify the table finally. But for tests, I just comment the pci device search and it works now!
Thank you very much again for your help! Best, Ning On 4/25/07, Mondrian Nuessle <[EMAIL PROTECTED]> wrote: > This is really strange. We are using the same setup, a biossavior with > Pm49FL004 part, and it works just fine... hmhm > > Regards, > Mondrian > > Ning (Michael) Qu wrote: > > Hi, Mondrian, > > > > Unfortunately, after patching flashrom, the results remain the same as > > before. Only the page 7 is programmed. I guess I should first check > > the WP pin of Savior, and then perhaps I need this patch to program > > it. Thanks for your help! > > > > Best, > > Ning > > > > On 4/25/07, Mondrian Nuessle <[EMAIL PROTECTED]> wrote: > >> Hi! > >> You need to enable writing to the flash. In case of the Iwill board, > >> some SuperIO GPIOs need to be properly set. > >> I sent an email to the list with a patch attached, which configures > >> flashrom to handle the iwill dk8_htx correctly. > >> > >> Regards, > >> Mondrian > >> > >> -- > >> Mondrian Nuessle University of Mannheim > >> Phone: +49 621 181 2717 Computer Architecture Group > >> Fax: +49 621 181 2713 http://ra.ti.uni-mannheim.de > >> mailto:[EMAIL PROTECTED] > >> > > > > > > -- > Mondrian Nuessle University of Mannheim > Phone: +49 621 181 2717 Computer Architecture Group > Fax: +49 621 181 2713 http://ra.ti.uni-mannheim.de > mailto:[EMAIL PROTECTED] > > -- linuxbios mailing list [email protected] http://www.linuxbios.org/mailman/listinfo/linuxbios
