Hi, I am working on Tyan S2865 (CK804 based). Probably time I post a patch to go into the tree.
Working: single DIMM memory slot PC400 DDR ECC 1 of 4 PCI slots PS/2 kerboard and mouse both onboard NICs, audio, usb, IDE 1 of 4 SATA ports (correcting mptable irq should bring up a 2nd port) atyfb, serial port all 3 PCI-e slots (2 x1 and one x16) flashrom, has PLCC32 LPC flash, southbridge supports 4MB tops i2c hardware monitor (DME1737 patch from lm-sensors mailing list) Not working: some sata ports, 3 PCI slots don't generage interrupts (but work for matrox millenium II PCI graphics card) onboard firewire hardware watchdog (DME1737 - i need to port driver for Linux) MSI interrupts (uses INTx mode) ACPI/PowerNow Untested: floppy parallel 2nd serial I agree it would be great to have a variety of single processor/inexpensive/fairly modern boards supported. Cheers, Jeremy On Fri, 2007-05-25 at 16:38 +0200, Uwe Hermann wrote: > Hi, > > there's been lots of talk about support for a modern and/or cheap desktop > board in the past. > > I think our best bet at the moment is to support many K8+CK804 and > K8+MCP55 boards. Is anybody out there already (or still) working on such > a mainboard at the moment? Any preliminary patches? I'm thinking about > getting one such board, but I don't want to duplicate any work someone > else might already have put into writing code... -- linuxbios mailing list [email protected] http://www.linuxbios.org/mailman/listinfo/linuxbios
