Quoting Jouni Mettälä <[EMAIL PROTECTED]>: > Using just one dimm made it better. It gave last line FILO version > 0.5(desktop) and date. Image is slightly modified. I hopefully > disabled > onboard vga. It is set to 2.0 and off. Also other things in my opinion > not so important now as paraller port and floppy are set off. Could > unconnected floppy drive affect to PNP errors? > > northbridge is changed by just using device number 0x1130 instead of 0x7120 > in northbridge.c > > Filo.elf is different this time too. > > Is the ram working good enough with one chip? Does elfload tell anythig to > you? > Have you tried ram_check() in auto.c? Sounds like you may have some memory initialization problems like I was having. You can try this:
1. Enable debugging output in raminit.c, build and run to get the bootlog. /* Uncomment this to enable debugging output. */ #define DEBUG_RAM_SETUP 1 2. As root with the factory bios do a lspci -xxx. 3. Compaire the 00:00.0 Host bridge from lspci -xxx to the Northbridge following SDRAM init: PCI: 00:00.00 from your bootlog. Especially the DRB registers. I had two DRB registers that were supposed to be reserved but they are not. I set those and boom it booted:-) Hope that helps. Thanks - Joe -- linuxbios mailing list linuxbios@linuxbios.org http://www.linuxbios.org/mailman/listinfo/linuxbios