On 15.10.2007 00:41, Harald Gutmann wrote: > after a friend of mine (wolfgang illmeyer) implemented the code to write to > the spi chip, i can finally give you the following output: > Great!
> %<-------------------------------------------------------------------- > benchvice flashrom # ./flashrom -m > gigabyte:m57sli -w > /home/hg87/src/linuxbios/buildrom-devel/linuxbios_onchip.rom > Calibrating delay loop... ok > No LinuxBIOS table found. > Found chipset "NVIDIA MCP55": Enabling flash write... OK. > Found board "GIGABYTE GA-M57SLI": Enabling flash write... Serial flash > segment > 0xfffe0000-0xffffffff enabled > Serial flash segment 0x000e0000-0x000fffff enabled > Serial flash segment 0xffee0000-0xffefffff disabled > Serial flash segment 0xfff80000-0xfffeffff enabled > LPC write to serial flash enabled > serial flash pin 29 > OK. > RDID returned c2 20 13 > MX25L4005 found at physical address: 0xfff80000 > Flash part is MX25L4005 (512 KB) > benchvice flashrom # ./flashrom -m > gigabyte:m57sli -v > /home/hg87/src/linuxbios/buildrom-devel/linuxbios_onchip.rom > Calibrating delay loop... ok > No LinuxBIOS table found. > Found chipset "NVIDIA MCP55": Enabling flash write... OK. > Found board "GIGABYTE GA-M57SLI": Enabling flash write... Serial flash > segment > 0xfffe0000-0xffffffff enabled > Serial flash segment 0x000e0000-0x000fffff enabled > Serial flash segment 0xffee0000-0xffefffff disabled > Serial flash segment 0xfff80000-0xfffeffff enabled > LPC write to serial flash enabled > serial flash pin 29 > OK. > RDID returned c2 20 13 > MX25L4005 found at physical address: 0xfff80000 > Flash part is MX25L4005 (512 KB) > Verifying flash - VERIFIED > benchvice flashrom # > %<------------------------------------------------------------------------------ > > i didn't try to boot the linuxbios until now, and the code is quite ugly and > not cleaned up these times. > > i'll try to get the code cleaned up in the next few days, and poste the code > to the list. > Great, thanks! The code I have also is not polished, so even if your code is ugly, it is better than no code. We can clean up that stuff together. I have a few patches pending to flashrom which restructure the SPI code, but they don't change function prototypes, so your code is likely to work fine even after my changes. > but now, i try to boot the linuxbios. > Good luck! Regards, Carl-Daniel -- linuxbios mailing list linuxbios@linuxbios.org http://www.linuxbios.org/mailman/listinfo/linuxbios
