Dear LinuxBIOS readers!
This is the automated build check service of LinuxBIOS.
The developer "uwe" checked in revision 2896 to
the LinuxBIOS source repository and caused the following
changes:
Change Log:
Some fixes for the BCOM WinNET100, mostly in Config.lb:
- Add missing entry for the NIC:
device pci 0f.0 on end # Ethernet (onboard)
- Drop the following lines:
register "com1" = "{115200}"
register "com2" = "{38400}"
Those entries hardcode the BAUD rate (as far as I can tell, please
correct me if I'm wrong). We don't want that -- instead the config option
TTYS0_BAUD in Options.lb should be used(?) I verified that dropping those
lines will not break serial output (COM1, 115200, 8n1).
- Enable IDE (PCI device 00:12.2) and add the following register lines
to tell the CS5530 code to actually enable IDE channel 0:
register "ide0_enable" = "1"
register "ide1_enable" = "0" # Not available/needed on this board
Tested with a 2.5" hard drive and FILO, works fine.
- Enable USB (PCI device 00:13.0), not sure why it was commented.
- Enable COM2 as it's used by the smartcard reader.
- Add CONFIG_COMPRESSED_PAYLOAD_LZMA to Options.lb, in order to fix
abuild for this board.
- Add some more comments.
Signed-off-by: Uwe Hermann <[EMAIL PROTECTED]>
Acked-by: Stefan Reinauer <[EMAIL PROTECTED]>
Build Log:
Compilation of arima:hdama is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=hdama&vendor=arima
Configuration of bcom:winnet100 has been fixed
Compilation of ibm:e325 is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=e325&vendor=ibm
Compilation of ibm:e326 is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=e326&vendor=ibm
Compilation of iei:juki-511p is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=juki-511p&vendor=iei
Compilation of iwill:dk8s2 is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=dk8s2&vendor=iwill
Compilation of iwill:dk8x is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=dk8x&vendor=iwill
Compilation of newisys:khepri is still broken
See the error log at
http://qa.linuxbios.org/log_buildbrd.php?revision=2896&device=khepri&vendor=newisys
If something broke during this checkin please be a pain
in uwe's neck until the issue is fixed.
If this issue is not fixed within 24h the revision should
be backed out.
Best regards,
LinuxBIOS automatic build system
--
linuxbios mailing list
linuxbios@linuxbios.org
http://www.linuxbios.org/mailman/listinfo/linuxbios
