On Aug 21, 2007, at 10:29 AM, Anton Vorontsov wrote:
> mmc_spi already tested to work. When it will hit mainline
> the only change that will be needed is replacing "spidev"
> with "mmc_spi".
>
> Signed-off-by: Anton Vorontsov <[EMAIL PROTECTED]>
> ---
> arch/powerpc/boot/dts/mpc832x_rdb.dts | 2 +-
> arch/powerpc/platforms/83xx/mpc832x_rdb.c | 50 ++++++++++++++++++
> +++++++++++
> 2 files changed, 51 insertions(+), 1 deletions(-)
>
> diff --git a/arch/powerpc/boot/dts/mpc832x_rdb.dts b/arch/powerpc/
> boot/dts/mpc832x_rdb.dts
> index e9c332f..1ac0025 100644
> --- a/arch/powerpc/boot/dts/mpc832x_rdb.dts
> +++ b/arch/powerpc/boot/dts/mpc832x_rdb.dts
> @@ -211,7 +211,7 @@
> reg = <4c0 40>;
> interrupts = <2>;
> interrupt-parent = <&qeic>;
> - mode = "cpu";
> + mode = "cpu-qe";
> };
>
> [EMAIL PROTECTED] {
> diff --git a/arch/powerpc/platforms/83xx/mpc832x_rdb.c b/arch/
> powerpc/platforms/83xx/mpc832x_rdb.c
> index e021b08..cf58d06 100644
> --- a/arch/powerpc/platforms/83xx/mpc832x_rdb.c
> +++ b/arch/powerpc/platforms/83xx/mpc832x_rdb.c
> @@ -15,6 +15,7 @@
> */
>
> #include <linux/pci.h>
> +#include <linux/spi/spi.h>
>
> #include <asm/of_platform.h>
> #include <asm/time.h>
> @@ -24,6 +25,7 @@
> #include <asm/qe_ic.h>
>
> #include "mpc83xx.h"
> +#include "../../sysdev/fsl_soc.h"
we usually do #include <sysdev/fsl_soc.h>
>
> #undef DEBUG
> #ifdef DEBUG
> @@ -32,6 +34,54 @@
> #define DBG(fmt...)
> #endif
>
> +extern int par_io_data_set(u8 port, u8 pin, u8 val);
> +extern int par_io_config_pin(u8 port, u8 pin, int dir, int
> open_drain,
> + int assignment, int has_irq);
> +
> +static void mpc83xx_spi_activate_cs(u8 cs, u8 polarity)
> +{
> + pr_debug("%s %d %d\n", __func__, cs, polarity);
> + par_io_data_set(3, 13, polarity);
> +}
> +
> +static void mpc83xx_spi_deactivate_cs(u8 cs, u8 polarity)
> +{
> + pr_debug("%s %d %d\n", __func__, cs, polarity);
> + par_io_data_set(3, 13, !polarity);
> +}
> +
> +static struct spi_board_info mpc832x_spi_boardinfo = {
> + .bus_num = 0x4c0,
> + .chip_select = 0,
> + .max_speed_hz = 50000000,
> + /*
> + * XXX: This is spidev (spi in userspace) stub, should
> + * be replaced by "mmc_spi" when mmc_spi will hit mainline.
> + */
> + .modalias = "spidev",
> +};
> +
> +static int __init mpc832x_spi_init(void)
> +{
> + if (!machine_is(mpc832x_rdb))
> + return 0;
> +
> + par_io_config_pin(3, 0, 3, 0, 1, 0); /* SPI1 MOSI, I/O */
> + par_io_config_pin(3, 1, 3, 0, 1, 0); /* SPI1 MISO, I/O */
> + par_io_config_pin(3, 2, 3, 0, 1, 0); /* SPI1 CLK, I/O */
> + par_io_config_pin(3, 3, 2, 0, 1, 0); /* SPI1 SEL, I */
> +
> + par_io_config_pin(3, 13, 1, 0, 0, 0); /* !SD_CS, O */
> + par_io_config_pin(3, 14, 2, 0, 0, 0); /* SD_INSERT, I */
> + par_io_config_pin(3, 15, 2, 0, 0, 0); /* SD_PROTECT,I */
> +
> + return fsl_spi_init(&mpc832x_spi_boardinfo, 1,
> + mpc83xx_spi_activate_cs,
> + mpc83xx_spi_deactivate_cs);
> +}
> +
> +device_initcall(mpc832x_spi_init);
> +
> /*
> **********************************************************************
> **
> *
> * Setup the architecture
> --
> 1.5.0.6
> _______________________________________________
> Linuxppc-dev mailing list
> Linuxppc-dev@ozlabs.org
> https://ozlabs.org/mailman/listinfo/linuxppc-dev
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
