On Friday 14 September 2007, Josh Boyer wrote:
> A new binding for flash devices was recently introduced. This updates the
> Walnut DTS to use the new binding.
>
> Signed-off-by: Josh Boyer <[EMAIL PROTECTED]>
> ---
> arch/powerpc/boot/dts/walnut.dts | 17 ++++++++++++-----
> 1 file changed, 12 insertions(+), 5 deletions(-)
>
> --- linux-2.6.orig/arch/powerpc/boot/dts/walnut.dts
> +++ linux-2.6/arch/powerpc/boot/dts/walnut.dts
> @@ -137,6 +137,10 @@
> dcr-reg = <012 2>;
> #address-cells = <2>;
> #size-cells = <1>;
> + /* The ranges property is supplied by the bootwrapper
> + * and is based on the firmware's configuration of the
> + * EBC bridge
> + */
> clock-frequency = <0>; /* Filled in by zImage */
>
> [EMAIL PROTECTED],0 {
> @@ -144,13 +148,16 @@
> };
>
> [EMAIL PROTECTED],80000 {
> - device_type = "rom";
> - compatible = "direct-mapped";
> - probe-type = "JEDEC";
> + compatible = "jedec-flash";
> bank-width = <1>;
> - partitions = <0 80000>;
> - partition-names = "OpenBIOS";
> reg = <0 80000 80000>;
> + #address-cells = <1>;
> + #size-cells = <1>;
> + [EMAIL PROTECTED] {
> + label = "OpenBIOS";
> + reg = <0 80000>;
> + read-only;
> + };
There are not only Bamboo board running PIBS, but running U-Boot too. How
should we handle this different FLASH partitioning? Same goes for Ebony too
btw.
Best regards,
Stefan
_______________________________________________
Linuxppc-dev mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-dev
