Kumar Gala wrote:
> + * Freescale 83xx DMA Controller
> +
> + Freescale PowerPC 83xx have on chip general purpose DMA controllers.
> +
> + Required properties:
> +
> + - compatible : compatible list, contains 2 entries, first is
> + "fsl,CHIP-dma", where CHIP is the processor
> + (mpc8349, mpc8360, etc.) and the second is
> + "fsl,elo-dma"
Shouldn't we put some text somewhere that we're calling it the Elo controller
even though that word isn't used in the reference manual?
> + * Freescale 85xx DMA Controller
And 86xx.
> +
> + Freescale PowerPC 85xx have on chip general purpose DMA controllers.
> +
> + Required properties:
> +
> + - compatible : compatible list, contains 2 entries, first is
> + "fsl,CHIP-dma", where CHIP is the processor
> + (mpc8540, mpc8540, etc.) and the second is
> + "fsl,eloplus-dma"
> + - reg : <registers mapping for DMA general status reg>
> + - ranges : Should be defined as specified in 1) to
> describe the
> + DMA controller channels.
> +
> + - DMA channel nodes:
> + - compatible : compatible list, contains 2 entries, first is
> + "fsl,CHIP-dma-channel", where CHIP is the
> processor
> + (mpc8540, mpc8560, etc.) and the second is
> + "fsl,eloplus-dma-channel"
> + - reg : <registers mapping for channel>
> + - interrupts : <interrupt mapping for DMA channel IRQ>
> + - interrupt-parent : optional, if needed for interrupt mapping
> +
> + Example:
> + [EMAIL PROTECTED] {
Shouldn't this be [EMAIL PROTECTED]
> + #address-cells = <1>;
> + #size-cells = <1>;
> + compatible = "fsl,mpc8540-dma", "fsl,eloplus-dma";
> + reg = <21300 4>;
> + ranges = <0 21100 200>;
> + [EMAIL PROTECTED] {
> + compatible = "fsl,mpc8540-dma-channel",
> "fsl,eloplus-dma-channel";
> + reg = <0 80>;
> + interrupt-parent = <&mpic>;
> + interrupts = <14 2>;
> + };
The DMA controller and the DMA channels need a "device-id", so that they can
be identified by number. Some peripherals, like the SSI, can only use the
controller and channel number. This is what I have in my 8610 DTS:
[EMAIL PROTECTED] {
#address-cells = <1>;
#size-cells = <1>;
compatible = "fsl,mpc8610-dma", "fsl,mpc8540-dma";
--> device-id = <0>;
reg = <21300 4>; /* DMA general status register */
ranges = <0 21100 200>;
[EMAIL PROTECTED] {
compatible = "fsl,mpc8610-dma-channel",
"fsl,mpc8540-dma-channel";
--> device-id = <0>;
reg = <0 80>;
interrupt-parent = <&mpic>;
interrupts = <14 2>;
};
--
Timur Tabi
Linux Kernel Developer @ Freescale
_______________________________________________
Linuxppc-dev mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-dev