Reading table 4-30, and its footnotes, of the QUICC Engine Block
Reference Manual shows that the set of snum _values_ is not
necessarily just a function of the _number_ of snums, as given in the
fsl,qe-num-snums property.
As an alternative, to make it easier to add support for other variants
of the QUICC engine IP, this introduces a new binding fsl,qe-snums,
which automatically encodes both the number of snums and the actual
values to use.
For example, for the MPC8309, one would specify the property as
fsl,qe-snums = /bits/ 8 <
0x88 0x89 0x98 0x99 0xa8 0xa9 0xb8 0xb9
0xc8 0xc9 0xd8 0xd9 0xe8 0xe9>;
Signed-off-by: Rasmus Villemoes <rasmus.villem...@prevas.dk>
---
Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
index d7afaff5faff..05f5f485562a 100644
--- a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
+++ b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
@@ -18,7 +18,8 @@ Required properties:
- reg : offset and length of the device registers.
- bus-frequency : the clock frequency for QUICC Engine.
- fsl,qe-num-riscs: define how many RISC engines the QE has.
-- fsl,qe-num-snums: define how many serial number(SNUM) the QE can use for the
+- fsl,qe-snums: This property has to be specified as '/bits/ 8' value,
+ defining the array of serial number (SNUM) values for the virtual
threads.
Optional properties:
@@ -34,6 +35,11 @@ Recommended properties
- brg-frequency : the internal clock source frequency for baud-rate
generators in Hz.
+Deprecated properties
+- fsl,qe-num-snums: define how many serial number(SNUM) the QE can use
+ for the threads. Use fsl,qe-snums instead to not only specify the
+ number of snums, but also their values.
+
Example:
qe@e0100000 {
#address-cells = <1>;
--
2.20.1
