Currently on PowerNV the IOMMU group of a device is initialised in boot-time fixup which runs after devices are probed. Because this is only run at boot time hotplugged devices do not recieve an iommu group assignment which prevents them from being passed through to a guest.
This series fixes that by moving the point where IOMMU groups are registered to when we configure DMA for a PE, and moves the point where we add a device to the PE's IOMMU group into the per-device DMA setup callback for IODA phbs (pnv_pci_ioda_dma_dev_setup()). This change means that we'll do group setup for hotplugged devices and that we can remove the hack we have for VFs which are currently added to their group via a bus notifier. With this change there's no longer any per-device setup that needs to run in a fixup for ordinary PCI devices. The exception is, as per usual, NVLink devices. For those the GPU and any of it's NVLink devices need to be in a "compound" IOMMU group which keeps the DMA address spaces of each device in sync with it's attached devices. As a result that setup can only be done when both the NVLink devices and the GPU device has been probed, so that setup is still done in the fixup. Sucks, but it's still an improvement. Boot tested on a witherspoon with 6xGPUs and it didn't crash so it must be good.
