"Rob Herring (Arm)" <r...@kernel.org> writes: > The PPC64 specific MMIO setup open codes DT address functions rather > than using standard address parsing functions. The open-coded version > fails to handle any address translation and is not endian safe. > > I haven't found any evidence of what platform used this. The only thing > that turned up was a PPC405 platform, but that is 32-bit and PPC405 > support is being removed as well. CONFIG_TCG_ATMEL is not enabled for > any powerpc config and never was. The support was added in 2005 and > hasn't been touched since.
I found a post on the tpm list which says it was used in JS21, which would make sense given the time frame: https://lore.kernel.org/all/526ea6ff.2080...@linux.vnet.ibm.com/ As near as I can tell this was on a single machine type (the js21 circa 2006). The firmware on the machine didn't support establishing a root of trust, so use of the TPM was as a practical matter effective only for the other functions like random number generation and key management. The number of users who used the TPM for this on this machine was likely very small 7 years ago. The number of those machines still in service today is likely smaller still. The cross section of those two small numbers combined with those who want to run on a shiny new kernel has to be quickly approaching zero. The SLOF (firmware) code does confirm that, and includes the same compatible value as below, so I think that's pretty definitive: https://github.com/qemu/SLOF/blob/master/board-js2x/slof/tpm.fs \ Atmel TPM. new-device 500 1 set-unit s" tpm" 2dup device-name device-type s" AT97SC3201" compatible I used to have a JS21, but it got scrapped in a cleanup a few years back. I strongly doubt any others still exist, I couldn't find any on ebay :) > Rather than try to modernize and fix this code, just remove it. Acked-by: Michael Ellerman <m...@ellerman.id.au> (powerpc) cheers > diff --git a/drivers/char/tpm/Kconfig b/drivers/char/tpm/Kconfig > index e63a6a17793c..9b655e9fc7ab 100644 > --- a/drivers/char/tpm/Kconfig > +++ b/drivers/char/tpm/Kconfig > @@ -162,7 +162,7 @@ config TCG_NSC > > config TCG_ATMEL > tristate "Atmel TPM Interface" > - depends on PPC64 || HAS_IOPORT_MAP > + depends on HAS_IOPORT_MAP > depends on HAS_IOPORT > help > If you have a TPM security chip from Atmel say Yes and it > diff --git a/drivers/char/tpm/tpm_atmel.c b/drivers/char/tpm/tpm_atmel.c > index 9fb2defa9dc4..622c4abe8cb3 100644 > --- a/drivers/char/tpm/tpm_atmel.c > +++ b/drivers/char/tpm/tpm_atmel.c > @@ -15,7 +15,67 @@ > */ > > #include "tpm.h" > -#include "tpm_atmel.h" > + > +struct tpm_atmel_priv { > + int region_size; > + int have_region; > + unsigned long base; > + void __iomem *iobase; > +}; > + > +#define atmel_getb(chip, offset) inb(atmel_get_priv(chip)->base + offset) > +#define atmel_putb(val, chip, offset) \ > + outb(val, atmel_get_priv(chip)->base + offset) > +#define atmel_request_region request_region > +#define atmel_release_region release_region > +/* Atmel definitions */ > +enum tpm_atmel_addr { > + TPM_ATMEL_BASE_ADDR_LO = 0x08, > + TPM_ATMEL_BASE_ADDR_HI = 0x09 > +}; > + > +static inline int tpm_read_index(int base, int index) > +{ > + outb(index, base); > + return inb(base+1) & 0xFF; > +} > + > +/* Verify this is a 1.1 Atmel TPM */ > +static int atmel_verify_tpm11(void) > +{ > + > + /* verify that it is an Atmel part */ > + if (tpm_read_index(TPM_ADDR, 4) != 'A' || > + tpm_read_index(TPM_ADDR, 5) != 'T' || > + tpm_read_index(TPM_ADDR, 6) != 'M' || > + tpm_read_index(TPM_ADDR, 7) != 'L') > + return 1; > + > + /* query chip for its version number */ > + if (tpm_read_index(TPM_ADDR, 0x00) != 1 || > + tpm_read_index(TPM_ADDR, 0x01) != 1) > + return 1; > + > + /* This is an atmel supported part */ > + return 0; > +} > + > +/* Determine where to talk to device */ > +static void __iomem * atmel_get_base_addr(unsigned long *base, int > *region_size) > +{ > + int lo, hi; > + > + if (atmel_verify_tpm11() != 0) > + return NULL; > + > + lo = tpm_read_index(TPM_ADDR, TPM_ATMEL_BASE_ADDR_LO); > + hi = tpm_read_index(TPM_ADDR, TPM_ATMEL_BASE_ADDR_HI); > + > + *base = (hi << 8) | lo; > + *region_size = 2; > + > + return ioport_map(*base, *region_size); > +} > > /* write status bits */ > enum tpm_atmel_write_status { > @@ -142,7 +202,6 @@ static void atml_plat_remove(void) > tpm_chip_unregister(chip); > if (priv->have_region) > atmel_release_region(priv->base, priv->region_size); > - atmel_put_base_addr(priv->iobase); > platform_device_unregister(pdev); > } > > @@ -211,7 +270,6 @@ static int __init init_atmel(void) > err_unreg_dev: > platform_device_unregister(pdev); > err_rel_reg: > - atmel_put_base_addr(iobase); > if (have_region) > atmel_release_region(base, > region_size); > diff --git a/drivers/char/tpm/tpm_atmel.h b/drivers/char/tpm/tpm_atmel.h > deleted file mode 100644 > index 7ac3f69dcf0f..000000000000 > --- a/drivers/char/tpm/tpm_atmel.h > +++ /dev/null > @@ -1,140 +0,0 @@ > -/* SPDX-License-Identifier: GPL-2.0-only */ > -/* > - * Copyright (C) 2005 IBM Corporation > - * > - * Authors: > - * Kylene Hall <kjh...@us.ibm.com> > - * > - * Maintained by: <tpmdd-de...@lists.sourceforge.net> > - * > - * Device driver for TCG/TCPA TPM (trusted platform module). > - * Specifications at www.trustedcomputinggroup.org > - * > - * These difference are required on power because the device must be > - * discovered through the device tree and iomap must be used to get > - * around the need for holes in the io_page_mask. This does not happen > - * automatically because the tpm is not a normal pci device and lives > - * under the root node. > - */ > - > -struct tpm_atmel_priv { > - int region_size; > - int have_region; > - unsigned long base; > - void __iomem *iobase; > -}; > - > -#ifdef CONFIG_PPC64 > - > -#include <linux/of.h> > - > -#define atmel_getb(priv, offset) readb(priv->iobase + offset) > -#define atmel_putb(val, priv, offset) writeb(val, priv->iobase + offset) > -#define atmel_request_region request_mem_region > -#define atmel_release_region release_mem_region > - > -static inline void atmel_put_base_addr(void __iomem *iobase) > -{ > - iounmap(iobase); > -} > - > -static void __iomem * atmel_get_base_addr(unsigned long *base, int > *region_size) > -{ > - struct device_node *dn; > - unsigned long address, size; > - const unsigned int *reg; > - int reglen; > - int naddrc; > - int nsizec; > - > - dn = of_find_node_by_name(NULL, "tpm"); > - > - if (!dn) > - return NULL; > - > - if (!of_device_is_compatible(dn, "AT97SC3201")) { > - of_node_put(dn); > - return NULL; > - } > - > - reg = of_get_property(dn, "reg", ®len); > - naddrc = of_n_addr_cells(dn); > - nsizec = of_n_size_cells(dn); > - > - of_node_put(dn); > - > - > - if (naddrc == 2) > - address = ((unsigned long) reg[0] << 32) | reg[1]; > - else > - address = reg[0]; > - > - if (nsizec == 2) > - size = > - ((unsigned long) reg[naddrc] << 32) | reg[naddrc + 1]; > - else > - size = reg[naddrc]; > - > - *base = address; > - *region_size = size; > - return ioremap(*base, *region_size); > -} > -#else > -#define atmel_getb(chip, offset) inb(atmel_get_priv(chip)->base + offset) > -#define atmel_putb(val, chip, offset) \ > - outb(val, atmel_get_priv(chip)->base + offset) > -#define atmel_request_region request_region > -#define atmel_release_region release_region > -/* Atmel definitions */ > -enum tpm_atmel_addr { > - TPM_ATMEL_BASE_ADDR_LO = 0x08, > - TPM_ATMEL_BASE_ADDR_HI = 0x09 > -}; > - > -static inline int tpm_read_index(int base, int index) > -{ > - outb(index, base); > - return inb(base+1) & 0xFF; > -} > - > -/* Verify this is a 1.1 Atmel TPM */ > -static int atmel_verify_tpm11(void) > -{ > - > - /* verify that it is an Atmel part */ > - if (tpm_read_index(TPM_ADDR, 4) != 'A' || > - tpm_read_index(TPM_ADDR, 5) != 'T' || > - tpm_read_index(TPM_ADDR, 6) != 'M' || > - tpm_read_index(TPM_ADDR, 7) != 'L') > - return 1; > - > - /* query chip for its version number */ > - if (tpm_read_index(TPM_ADDR, 0x00) != 1 || > - tpm_read_index(TPM_ADDR, 0x01) != 1) > - return 1; > - > - /* This is an atmel supported part */ > - return 0; > -} > - > -static inline void atmel_put_base_addr(void __iomem *iobase) > -{ > -} > - > -/* Determine where to talk to device */ > -static void __iomem * atmel_get_base_addr(unsigned long *base, int > *region_size) > -{ > - int lo, hi; > - > - if (atmel_verify_tpm11() != 0) > - return NULL; > - > - lo = tpm_read_index(TPM_ADDR, TPM_ATMEL_BASE_ADDR_LO); > - hi = tpm_read_index(TPM_ADDR, TPM_ATMEL_BASE_ADDR_HI); > - > - *base = (hi << 8) | lo; > - *region_size = 2; > - > - return ioport_map(*base, *region_size); > -} > -#endif > -- > 2.43.0
