Hi,
kernel- 2.6.29
Debug technique: KGDB
The PowerPC kernel does not initialize the PPC440 DBCR0 register. This
prevents the use of software breakpoints in case of internal debug
mode. Looking into head_fsl_booke.S for initialization of DBCR0 is
used by boot-loaders.
It seems head_44x.S lacks this step of DBCR0 register initialization.
So fixing this with initializing the DBCR0 register as shown below :
Subject: [PATCH] powerpc: 44x: Initialize DBCR0 for targets not having
bootloader
The kernel does not initialize the PPC440 DBCR0 register.
This prevents (among other things) the use of software
breakpoints with GDB. The boot loaders probably do initialize
this but few targets run without a boot loader
---
arch/powerpc/kernel/head_44x.S | 12 ++++++++++++
1 files changed, 12 insertions(+), 0 deletions(-)
diff --git a/arch/powerpc/kernel/head_44x.S b/arch/powerpc/kernel/head_44x.S
index a4a890a..b413bc4 100644
--- a/arch/powerpc/kernel/head_44x.S
+++ b/arch/powerpc/kernel/head_44x.S
@@ -240,6 +240,18 @@ skpinv: addi r4,r4,1 /*
Increment */
lis r4,interrupt_b...@h /* IVPR only uses the high 16-bits */
mtspr SPRN_IVPR,r4
+#if !defined(CONFIG_BDI_SWITCH)
+ /*
+ * The Abatron BDI JTAG debugger does not tolerate others
+ * mucking with the debug registers.
+ */
+ lis r2,dbcr0_...@h
+ mtspr SPRN_DBCR0,r2
+ isync
+ /* clear any residual debug events */
+ li r2,-1
+ mtspr SPRN_DBSR,r2
+#endif
/*
* This is where the main kernel code starts.
*/
Any suggestions or comments on this ?
Thanks,
-Srikant
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
