Hi Pete,
On Mon, Aug 5, 2013 at 4:07 PM, Peter LaDow <pet...@gocougs.wsu.edu> wrote:
However, replacing the 82540 based card with either a 3com 3C905TXM or
the Netgear FA331, there is no response on the 0x10 IDSEL line. Thus
it appears these cards are NOT responding to configuration reads. I
think I have to break out the scope and probe around for the 5V/3V. I
wouldn't think that the supplies are the issue since these are
universal cards, and as I understand it either 3V3 _or_ 5V can be
present, so these should work fine. Yet they aren't responding to PCI
configuration cycles.
It depends on what you define "Universal PCI" as :)
My definition is that the board works with either 5V or 3.3V PCI
signals. However, that definition does not tell you where the device
draws power from.
I suspect the lack of either the 5V or 3.3V power rail to the card
might be the problem.
Did you probe the PCI edge connect to see what supplies were present?
A few more notes. I tried a variety of other cards, such as a PCI
modem (WinMode, ack), a WinTV card, and a PCI based 802.11 card. All
of them enumerate perfectly.
These could all be 3.3V cards ...
Perhaps it is a BIOS option ROM like you suggested earlier. The
3c90xC reference manual I found
(http://people.freebsd.org/~wpaul/3Com/3c90xc.pdf) mentions an option
ROM (and there is an Atmel part stuffed). I can't find any technical
information on the FA331 (yet), so I don't know about it.
But regardless, wouldn't enumeration have to occur before any option
ROM could even be used?
I've never had a card with an option ROM, so can't comment. I'd have
to look at the PCI spec. If you want me to look, let me know.
Cheers,
Dave
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
