On Tue, 2 Jun 2015 12:43:16 +0200 Dinar Valeev <[email protected]> wrote:
> On Tue, Jun 2, 2015 at 12:29 PM, Nikunj A Dadhania > <[email protected]> wrote: > > Dinar Valeev <[email protected]> writes: > > > >> On Tue, Jun 2, 2015 at 11:47 AM, Nikunj A Dadhania > >> <[email protected]> wrote: > >>> Dinar valeev <[email protected]> writes: ... > >>>> @@ -290,36 +286,34 @@ static void check_key_code(uint8_t *buf) > >>>> case 0x49: > >>>> write_key(0x1b); /* > >>>> INS */ > >>>> write_key(0x5b); > >>>> - write_key(0x31); > >>>> + write_key(0x32); > >>>> write_key(0x7e); > >>>> break; > >>>> > >>>> case 0x4a: > >>>> write_key(0x1b); /* > >>>> HOME */ > >>>> write_key(0x5b); > >>>> - write_key(0x32); > >>>> - write_key(0x7e); > >>>> + write_key(0x48); > >>> > >>> Looking at accept.fs - handle-ESC-5b ... > >>> > >>> : handle-ESC-5b > >>> key > >>> dup 31 = IF \ HOME > >>> key drop ( drops closing 7e ) handle-^A > >>> ELSE > >>> dup 33 = IF \ DEL > >>> key drop handle-^D > >>> ELSE > >>> dup 34 = IF \ END > >>> key drop handle-^E > >>> ELSE > >>> dup 1f and handle-CSI > >>> THEN > >>> THEN > >>> THEN drop > >>> ; > >>> > >>> > >>> ... following change is sufficient: > >>> - write_key(0x32); > >>> + write_key(0x31); > >>> > >> Home sequence for me is: ^[[H > > > > Can you check the above change in your setup ? > That works as well. Not sure, but IIRC some of these key codes depend on the keyboard layout that you are using. What keyboard layout (i.e. language) do you use? Thomas _______________________________________________ Linuxppc-dev mailing list [email protected] https://lists.ozlabs.org/listinfo/linuxppc-dev
