Hi, I am trying to boot custom board with PPC 750.
* I tftp'd the zImage into the target and when I give "go" command, it gives exception error. I can't understand what is going on. Below are the copy paste of it. I am using "powerboot" as the boot loader. - When I got the kernel from bk source (or from HHL 1.2), I had to explicitly say "n" to CONFIG_FB in arch/ppc/config.in. If not, I was getting compilations errors. Does this has any thing to do with booting. - I also tried with HHL 1.2 version (kernel 2.2.14). I was having the same problem of exception there also. * I know this is a basic question... What is "Prep" and "Chrp". zImage built had these two suffixes to it. Can some one please help me out. Thanks in advance. PowerBoot> netload zImage 400000 10.149.4.228 10.149.4.28 Ethernet controller diagnostics...pass Init Ethernet Controller MII-Port and PHY-Device PHY-Device at 100MB/s negotiated LAN-controller at address FE880000 set to Ethernet 12:00:34:23:56:45 Transmitting ARP-REQUEST... Reception of ARP-REPLY Transmitting TFTP-REQUEST to server 00:60:08:5A:F0:AC, IP 10.149.4.28 PACKET:1080 - loaded $00400000..$00486E65 (552550 bytes) PowerBoot> go 400000 exception occured: 0x700 SRR0 = 0x00400000 SRR1 = 0x0008B030 MSR = 0x00000030 DAR = 0x00000000 HID0 = 0x8010C004 HID1 = 0x70000000 L2CR = 0xBD080000 *** Program Exception *** PowerBoot> -- Siva ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
