Hello All, I am working with a pci based vga card. I have connected the vga card next to the pci slot of my target processor on the baseboard. I have connected a monitor to the vga card. When i boot linux from minicom, i could see all the kernel log messages on both the minicom and vga card monitor. But on the vga monitor, i could not see any messages after asking for login as below: . .
Mounting filesystems Running depmod Setting up networking on loopback device: Setting up networking on eth0: eth0: PHY is Marvell 88E11x1 (1410cc2) Adding static route for default gateway to 192.168.3.1: Setting nameserver to 192.168.0.1 in /etc/resolv.conf: Starting inetd: login: Though i am entering my login and passwd at the minicom, nothing comes on to the vga monitor. But i am able to write to vga monitor using the following commands from minicom: # echo "Hello" > /dev/tty1 # echo "Hi " > /dev/tty1 My requirement is to get on the vga monitor whatever i am typing on the minicom after logging into the linux like . ls or pwd commands. Anyone pl help me. Thanks & Regards Sudheer -------------- next part -------------- An HTML attachment was scrubbed... URL: http://ozlabs.org/pipermail/linuxppc-embedded/attachments/20060807/24f772fe/attachment.htm
