In message <4.3.2.20011008074637.00c64340 at falcon.si.com> you wrote: > > For PPCBoot, I made MII serial interface routines for the EST > (WindRiver) SBC8260 board. This was a general purpose implementation, > customizable for different hardware by changing the #defines that > toggled the I/O port pins. I also added a "mii" command that allows > you to read and write the MII registers from the command line. I was > able to read and write the EnableSemi (Lucent) PHY, which is a "dongle" > type PHY provided by EST. This could be helpful for you for poking > around in the PHY. If your needs are not too complex, it may be > sufficient to initialize the PHY and let it run autonomously. > > I submitted patches to Wolfgang, but it appears they have not been > rolled into the source yet. If you want a patch, reply to my email > address and I'll send you one.
Sorry for the delay, but it's my first day in the office after 3 weeks of vacation, and I'm still trying to figure out where to start working on all the things that piled up... Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de C makes it easy for you to shoot yourself in the foot. C++ makes that harder, but when you do, it blows away your whole leg. -- Bjarne Stroustrup ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/