It turns out that BDI has a few different versions. BDI for Codewarrior, BDI for GDB, etc. I just heard from Codewarrior that BDI for Codewarrior doesn't support MMU, which means address translation is not supported. I have to buy BDI for GDB.
About your question, I downloaded the zImage.initrd at 0x800000. I didn't turn on the default command line. Now I turn on the default command line as CONFIG_CMDLINE="mem=128M ramdisk_size=20480 console=ttyS0,9600 console=tty0 root=/dev/ram init=/bin/sh" The Sandpoint X3 has 128M ram and my ramdisk size is 20M. It should be right, isn't it? Dong-In -----Original Message----- From: [EMAIL PROTECTED] [mailto:owner-linuxppc-embedded at lists.linuxppc.org] On Behalf Of Mark A. Greer Sent: Tuesday, May 20, 2003 2:15 PM To: dong in kang Cc: linuxppc-embedded at lists.linuxppc.org Subject: Re: Kernel parameters (Sandpoint X3 with Altimus MPC755) dong in kang wrote: > As a debugging tool, I'm using Metrowerks Codewarrior v.6.0 running on >Windows 2000 platform. The BDI2000 for Codewarrior is connected to the >JTAG port of the Sandpoint X3. >I used the Codewarrior to load the linux kernel to the SDRAM of the >Sandpoint X3. >Of course, I used GCC to compile Montavista Linux kernel. >(I heard that BDIgdb is the best tool for Linux kernel debugging. >I'm considering purchasing BDIgdb. > Okay, that helps...I think. I still don't know what "BDI2000 for codewarrior" means/is but anyway... For right now, I recommend just using the telnet interface to the bdi. Its simple and works. You can download the zImage thru that interface (and tftp). The bdi manual has a page with all the cmds on it. Also, while using the telnet interface, use only hard breakpoints (which means you can only have one set at a time). > Currently, I have a problem of enabling >mmu. >After the initial boot part of the Linux finishes setting up BATs and >enables the mmu, the address translation is not done properly. So, when >the kernel jumps to 0xC0000000, it jumps to physical address >0xC0000000. It crashes there. I suspect BDI2000 with Codewarrior does >not support mmu. > > You shouldn't be having problems like that. Are you sure you used a valid .config when you built the kernel? What address did you download the zImage to? Did you try building/running the non-initrd image (zImage.sandpoint)? Mark ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
