How and where? I found that the PHY address in the manual is 0b00000 and in the code PPC405_PCI_PHY_MEM_BASE is set to 0x80000000.
Op do 26-06-2003, om 20:39 schreef Steven Blakeslee: > Did you enable the phy in the Board Control Status Register? > > -----Original Message----- > From: Toni Van Remortel [mailto:t.vanremortel at ha.be] > Sent: Thursday, June 26, 2003 10:01 AM > To: PPC Mailinglist > Subject: EP405 network interface > > > > Hi all, > > I cannot get the NIC working on my EP405. I used the ep405_config from > the linuxppc_2_4_devel tree. > > This is a part of the output: > > ... > loop: loaded (max 8 devices) > eth0: No PHY device found. > removing net dev > ... > > So it seems that the kernel doesn't find the NIC (but it is there, and > working, ep-bootloader can use it to download the image). > > Anybody an idea? > > I already checked the NIC support, and the onboard-IBM NIC support is > enabled. > > Regards, > -- > Toni Van Remortel > Wetenschappelijk Medewerker - D-science lab > Tel: 03 205 61 72 - Fax: 03 205 61 95 > E-mail: t.vanremortel at ha.be > > > ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
