The fcc driver that was working for ppcboot was in version 0.8.2, however the 0.8.3 will have the fixes for the EST SBC8260.
The 2.4.1 kernel I am using came from kernel.org. I didn't realize that there were updates in Bitkeeper tree. I'll try the latest Bitkeeper kernel. Regards, Oliver -----Original Message----- From: Dan Malek [mailto:[EMAIL PROTECTED] Sent: Thursday, March 08, 2001 6:36 PM To: Oliver Brown Cc: linuxppc-embedded at lists.linuxppc.org Subject: Re: EST SBC8260 and Canary CTX-1170 Oliver Brown wrote: > I can't generate any traffic on the fast ethernet port. The CTX-1170 worked at one time on the EST board. Unfortunately, I had to make little changes for just about every different 8260 board I have seen. Further, my EST boards have all failed in some way or another so I can't even test this anymore. Even when it "worked", I had trouble with some 10/100 switches. > Ppcboot works fine on this setup, so I know that the hardware is > working. Is this driver available from sourceforge, or is it something you have locally? I would like to look at it and I may see some differences. Most of the changes surround the MDIO interface and the software "clocking" of the bits on those lines. The PHYs seem sensitive to timing I just can't get right with the software. I was able to get one, or a small subset, working at the same time, but not all of them at once. -- Dan ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
