Setting 2 ports in 860T

[Arturo Nunez]

Hello:
        As a newby had some problems compiling the kernel, but finally I could
        do that.
        Now my system is a :
        -RPX CLLF
        -CPU=XPC860TZP50B5

        I have compiled the kernel 2.4 from bitkeeper.
        Basically doing :
        -       make rpxcllf_config
        Now when I boot the board with the new kernell, even it recognizes both
        ports,10 and 100 Mbits, as eth0 and eth1, I cant work with the 100
        port.
        The 10 port gets and Ip using dhcpd
        I manually give and IP to the 100 port.
        But when I disconnect the cable from the 100 port, as a test, the 10
        port answers.
        So it seems to be that the 100 port haven been totally configured.

        Any Suggestion will be appreciate.

        Regards

        Arturo Nunez


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/