Correct it. I only turn on OHCI in kernel configuration, not UHCI. Thanks, Johnson Cheng
-----Original Message----- From: [EMAIL PROTECTED] [mailto:linuxppc-embedded-bounces at ozlabs.org] On Behalf Of JohnsonCheng Sent: Saturday, July 23, 2005 10:24 AM To: 'Stefan Nickl' Cc: linuxppc-embedded at ozlabs.org Subject: RE: How NEC uPD720101 USB chip work well on linux2.6.12 I tried this case before, only turn on UHCI option in kernel. The conclusion is two USB port have the same result ( Kernel Oops), and another one has no response. Do you know if I want to set these three USB port sharing the same IRQ, where to modify it in kernel 2.6.12? Thanks, Johnson Cheng -----Original Message----- From: [EMAIL PROTECTED] [mailto:linuxppc-embedded-bounces at ozlabs.org] On Behalf Of Stefan Nickl Sent: Monday, August 22, 2005 9:55 PM To: JohnsonCheng Cc: linuxppc-embedded at ozlabs.org Subject: Re: How NEC uPD720101 USB chip work well on linux2.6.12 On Fri, 2005-07-22 at 20:26 +0800, JohnsonCheng wrote: > Dear All, > > > I use NEC uPD720101 USB chip, 2 OHCI and 1 EHCI, I also have turn on > the following options in kernel menuconfig: [...] > [*] USB Support / EHCI HCD (USB 2.0) support [...] > > > But when I plug-in a USB mouse, then Kernel Oops.. > > I use MPC8241 CPU, and there are three USB ports sharing the same IRQ > on my borad. I recently came across similar trouble with a chip from this series, the uPD720113 and another one in a off-the-shelf USB hub which I tried for reference. It may have been even the 101, but I'm not sure. Anyways, I've also seen hard resets with 2.6.12 to 2.6.13-rc-something, albeit in a x86-environment. The system would reset hard when plugging something after the hub or the hub itself, in case of the 113 it crashed 100% as soon as the hub was attached or detected during bootup. With the off-the-shelf hub, it was somewhat more random. In my case, disabling the EHCI controller in the BIOS helped, so you may try to disable the USB "2.0" support in the kernel config and see what happens. No problems running the system with only UHCI for some weeks now. I've deferred this problem because Hi-Speed is not an issue to me now, but I'd be curious to hear and test things if somebody had a take on this. Regards, -- Stefan Nickl Kontron Modular Computers _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded at ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded at ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded