Jerry Van Baren wrote: > > Your PPCBoot image is linked at 0x40000000 and your convert defaults are > converting from 0xfe000000..0xfe020000 (this is where EST puts the boot > memory unless you've changed the HRCW to ORG it at 0x00000000 -- glossing > over quite a few details here). Anyway, there ain't no data in that range, > which is exactly what the error message is telling you. > > The EST convert utility doesn't allow you to relocate the code, only to set > the lower and upper boundaries of the conversion. You can use an elf tool > (objcopy) to re-org the code or change your link mechanism to re-org your > code. You can also leave it at 0x40000000 and change your visionICE setup > to map the ROM into that memory area (hmm, isn't that the secondary > flash? Maybe you just need to program it and switch your CS0/CS6 jumper).
Yes that is the start of Flash. For our final product we want our bootloader to live in Flash but I'm rethinking that for the EST board. >From what I've read on the list is sounds like PPCBoot wants to live in ROM on the sbc8260 right? Is the above documented anywhere? I don't feel the need to reinvent the wheel for this board and I'd rather start off the right way. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
