Hi,
I have some questions about the Cypress c67x00 code that was posted a few days
ago.
I got the many patches from the git (thanks Grant!), but I am wondering,
How did you guys fix up the Kconfigs to work with the Xilinx Virtex-4 fpga?
My hw guys have put the cypress chip on 'the system ace'(OPB?) bus, a 16 bit
bus, and I have the address to it.
But its definetely not PCI, and if you use a plain kernel tree like I have, I
cannot access any features without turning on the PCI options. Which of course
fails, since I have no PCI parameters to feed the code.
Perhaps a better question is: Is this code intended for the Virtex-4?
If no, then I will have to fix it up.
Thanks,
Joe Robertson
[EMAIL PROTECTED]
CONFIDENTIALITY
This e-mail message and any attachments thereto, is intended only for use by
the addressee(s) named herein and may contain legally privileged and/or
confidential information. If you are not the intended recipient of this e-mail
message, you are hereby notified that any dissemination, distribution or
copying of this e-mail message, and any attachments thereto, is strictly
prohibited. If you have received this e-mail message in error, please
immediately notify the sender and permanently delete the original and any
copies of this email and any prints thereof.
ABSENT AN EXPRESS STATEMENT TO THE CONTRARY HEREINABOVE, THIS E-MAIL IS NOT
INTENDED AS A SUBSTITUTE FOR A WRITING. Notwithstanding the Uniform Electronic
Transactions Act or the applicability of any other law of similar substance and
effect, absent an express statement to the contrary hereinabove, this e-mail
message its contents, and any attachments hereto are not intended to represent
an offer or acceptance to enter into a contract and are not otherwise intended
to bind the sender, Sanmina-SCI Corporation (or any of its subsidiaries), or
any other person or entity.
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded