Steven Hein wrote: > Kim Phillips wrote: >> On Fri, 01 Feb 2008 12:52:25 -0600 >> Steven Hein <[EMAIL PROTECTED]> wrote: >> >> >>> The one main difference in this board is how eth0 is wired. >>> We have a Broadcom GbE switch part, and UCC1 eth is wired >>> directly to that switch (no PHY). (This where I needed to >>> >> >> sounds like you ran into some h/w errata. if on rgmii, you might >> want to find a way to program the switch for rgmii with internal delay >> (8360 rev.2 rgmii-id rx & tx; 8360rev2.1 rgmii-rxid (i.e. for rx >> only)). If not, I'd contact fsl tech support directly. >> >> Kim >> > > I would suspect HW.....but this WORKS with the 2.6.16 kernel > I was using! That's why I suspect that I still don't have > something configured right in my device tree, or something > else I missed in the new kernel. But I can't > figure out what it is.... :-( I've poured over the code in > the old versus new (both the ucc_geth driver and the platform > initialization in the old, and the device tree in the new) > and can't figure out what I missed! And like I said, a > kernel with the same config (other than changing the platform) > works on my MPC8360E-MDS board. Granted, that doesn't have > this direct switch connection...... > > I did look at the code related to the HW errata (QE_ENET18). > But we're using GMII to the switch....and that workaround > code wasn't in active in my old kernel (it was there, but > commented out). > > Any other thoughts? Has anyone seen this symptom before? > > Steve > Okay....I found it! Started poking at the UCCE registers and found that the FIFO sizes weren't right. This led me to find a bug in my ucc_geth interface to the fixed-link PHY driver: the code to reconfigure the MURAM FIFO's for Gigabit operation wasn't being executed for no-phy configs! All is well once I changed this.
Sorry for the noise..... (glad I found this before submitting my patch! ;-) Steve -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Steve Hein ([EMAIL PROTECTED]) Engineering Diagnostics/Software Silicon Graphics, Inc. 1168 Industrial Blvd. Phone: (715) 726-8410 Chippewa Falls, WI 54729 Fax: (715) 726-6715 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded